Where is it and how do i replace it
2006-10-16 15:38:18 · 5 answers · asked by Anonymous in Cars & Transportation ➔ Maintenance & Repairs
i own a repair shop,and if your looking at the engine its on the left side of it down about half way,to replace it you disconnect the battery and then remove the lines from it and then remove the two bolts that hold it on,be care full and don't loose the push rod that's in there,it will come down a little on It,once you have the old one of clean the gasket area,and then install the new one on it,be care full about getting the rod back on place on It,and then tighten it back up,re-install the lines ,and your done,after you start it make sure there are no leaks from it,that's pretty much it,just be care full ,good luck,i hope this help,s.
2006-10-16 15:48:11 · answer #1 · answered by dodge man 7 · 0⤊ 0⤋
It will be located on either the front left or right of the engine. Down low on the side. Most cars these days have brackets in the way. So if you are not mechanically inclined, take it to a mechanic.
You will need to check and see which items are in the way. You will likely have to remove things like the alternator or steering pump. The fuel pump itself is easy to remove after the other stuff is out of the way. You will have to remove two hoses. One to the pump, one out of the pump. These may be held on by nuts or maybe hoses. Take them off. Now you will have to remove the two bolts holding the pump to the block. Take them out and the pump will come off. You may need to tap it with a hammer to knock it loose. Now, scrape all of the old gasket off. Put some gasket glue on the new gasket and the block. Look up inside if you can. If not feel up inside. If you feel a rod blocking the entrance of the pump opening, then you will have push it up out of the way while you quickly slip the new pump into the hole. If the rod will not move enough to allow you to inset the new pump, you will have to turn the engine a bit to allow the rod to move up a bit more. Bump it over a bit with the ignition key. You may have to do this more than once. After you get the pump back in, tighten up the bolts and put hoses on, then re-assemble the rest of it.
Good luck!.
2006-10-16 23:05:55 · answer #2 · answered by It All Matters.~☺♥ 6 · 0⤊ 0⤋
You should have an electric pump in the fuel tank.
2006-10-16 23:32:13 · answer #3 · answered by B H 3 · 0⤊ 0⤋
its mounted on the side of your engine. follow your gas line down the side of the engine.
2006-10-20 17:34:02 · answer #4 · answered by duc602 7 · 0⤊ 0⤋
I suggest you visit Http://www.ChiltonManuals.com and you should find your answer there. ;)
2006-10-16 22:45:00 · answer #5 · answered by Chuck S 3 · 0⤊ 0⤋