What should I do if my gas hot water heater's pilot light is lite but the burner will not come on?

Answer 1

If your pilot lite is "lit" then the pilot thermocouple is fine. If the thermocouple was bad the pilot would not stay lit.

I suggest increasing your water temperature setting on the heater. If you increase this the burner should fire, if it does not than your problem is in the thermostat or thermocouple from the water tank that controls your burner.. This is called a demand/feedback loop, i.e. your temperature setting is the demand and the feedback loop comes from the actual temperature in the hot water tank. Before you scrap the heater check the warranty.

Answer 2

i've got been setting up and repairing those issues for the final 35 years, and the extra contemporary, (4-5 years previous), gadgets with the sealed pilot factors are a real soreness. The piezo igniters do each now and then flow undesirable, yet as Ed mentioned, they do no longer continuously spark on each push and that they are fairly no longer uncomplicated to work out once you may bend over so far to look via that little window. i might attempt it back, making confident to stick to the lights technique intently and in case you purely will no longer be able to get it to lite, Dean is real. you are able to take the steel plate with the window off the tank and lite it manually. i exploit a butane tournament, like those you employ to lite a BBQ. they have a solid long attain and many times a solid flame which will lite the hollow area and show you how to work out the place the pilot is. as quickly as you have the pilot relit, reinstall the plate earlier turning the main effectual valve on and the thermostat up. The producer of this unit won't deliver somebody out to repair it under guarantee for such a small element. What they'll do is to deliver you a factor and you will could desire to locate somebody to place in it. And ultimately, for the two between the Joe's, you adult men could in all probability take extra time to study the question earlier answering. They very it appears that evidently suggested that they grew to become off the pilot to be risk-free around the epoxy paint they have been using. it incredibly is not any longer a warrantiable situation.

Answer 3

Sounds like the thermostat is out. First try turning the thermostatic controller to a higher setting. If this does not work, you will either need to replace it or replace the entire water heater. A plumber will be able to advise you on this. Or if you feel that you have enough skills to do it. Remove it from the heater tank. It screws in, you will need to unhook all of the lines and then use a pipe wrench to unscrew it. Take it to a plumbing and heating supply and get a new replacement. Put back together and you all set. Please remember to turn the gas off first.

Answer 4

Call the Gas Company..asap

Answer 5

Mine has a nob that controls the temperature, and when my water heater wouldn't come on, I turned it up a bit.

Answer 6

Make sure the tip of the thermocoupler is in the pilot flame and / or replace it.

Answer 7

your thermal coupler could be out , try a long lighter to heat the sensor up more it is located right their with your pilot light , best to pull it out and clean or replace

Answer 8

1st check the themostat. It sounds like a safety issue so you might want to call a professional, thats just something that you dont want to mess up on if your not sure what your doing.