Has anyone removed laminate floors & re-installed? I need to install underlayment,to stop the noise.?

Answer 1

SHOULD HAVE HAD SOLID WOOD FLOORING FIRST TIME NOT CHEAP CRAP LAMINATE

Answer 2

The benefits of laminate don't stop with the look and feel of the surface. These products are usually installed over a foam-cushion underlayment. This cushion provides resiliency so the planks absorb shock and provide a natural sound. This also means the floor is a little easier on your feet.

Durability is another key feature. Many laminate flooring products are impervious to most stains and very resistant to scratches. The boards are prefinished at the factory and often feature a built-in edge sealant that protects against moisture absorption. Some laminate flooring manufacturers even offer a lifetime wall-to-wall warranty against wear-through, stains, fading and water damage from everyday spills and damp mopping.

Answer 3

If nailed, set the circular saw depth very shallow, then make cuts to score the flooring, to get started in removing, after that find the squeak, drill pilot holes using a low root screws that will hold, long enough to go though the underlayment to reach the joist maybe 3 > 4 inches in lenght, while walking mark the problem areas, find the joist, drill and screw, be patient, as this will be worth all the extra work in the end, to locate the joist > the joist will be at right angles to the sub floor, or look for nails or screws, making sure you have found the joist, then prepare to drill the correct size pilot hole then screw away, if after all this is done check for level, then use leveling compound, if really bad you may have to use shims.

Answer 4

It can be a nightmare taking laminate up!
I took mine up recently to lay a new one and a lot of it broke due to the T+G being nailed in.

If you have T+G laminate that is nailed you're probably screwed - I suppose you could be OK if you're very careful.

If you using the new click-lock stuff then you might have an easier time of it. This stuff is definately easier to use!

Just remember where all the peices go because you'll NEVER figure it out from scratch!


Good luck!

Answer 5

Been getting complaints have we?

It's a big job. Easier to install carpet and underlay on top of the laminate flooring. This will prevent noise, and also protect your expensive laimnate floor.

Answer 6

What type of "noise" are you talking about? The new floor clacking on top of the old floor, or the old floor squeeking? You can just use a circular saw to cut it out around the edges & prep the underlying floor correctly before re-installing it. You will probably have to use a different colored edging around it unless you are lucky enough to have some of the old flooring left.

Answer 7

We just laid our laminate flooring a few months ago. I've had to replace pieces in the middle of the floor (where I've dropped hard or sharp things on it). Basically if its the newer type its just click & go (or unclick & go) dependnig on whether your laying it or taking it up. Either way, just keep all of the end pieces in order so you don't have to make any extra cuts. The full pieces will fit anywhere on the floor. Its a snap and my laminate floors are not noisy or cheap.

Answer 8

this is extra beneficial? relies upon on the extensive-unfold of product you get in each.. this is far less annoying to place in? relies upon on how on hand you're. if your room is over 12' in the two direction I wouldn t do a vinyl. Seaming isn t for the extensive-unfold DIY er.. You ll get a nicer, ordinary look with a laminate yet once you have pets who would have injuries, then a vinyl could be a thank you to bypass. if your on hand the laminate would be very effective in case you get a stable product. You don t spend that rather extra and the extensive-unfold can get plenty extra beneficial. Now in case you have pets ( or youngsters who spill)and desire a laminate look , verify out the site visitors grasp appeal, it rather is a laminate form look, common to place in and is water data and espresso-priced.. Any questions you could e mail me by my avatar..GL

Answer 9

If the floor was laid within the last 5 years it is probably the type that clips together, in which case you will be able to lift it without any damage and replace it. Prior to that it was made from a chip board material that you had to glue together. If is the second type then all you can do is leave it or replace it. I hope this helps.

Answer 10

It's usually glued down. but if you can get it started,it shouldn't be too hard to get up with an ice-hoe @ a 35 degree angle. Check your local hardware store as to solvents to loosen the glue. I'm only guessing that you are going to put 1/4 luann down as underlayment. if your current floor is buckling,or heaving, you might have a subfloor problem.

Answer 11

You can use a cork underlayment in addition to the foam underlayment to help with the sound.