This only happens if i dont start the bike for a few days (3) and if i put new plugs in it is ok for 3 days then they go again i have haad the CDIs and coils checked and renewed both of them and the pickups but the plugs still stop working (plugs or what workshop manual says to use), any help will be gladly welcome
2006-10-10 03:01:15 · 2 answers · asked by steve j 1 in Cars & Transportation ➔ Motorcycles
The cylinders fire 1&4 or 2&3 so it probably isnt ignition.
Check plug wires are fitted to correct plugs
The carbs get fuel either from a common line or 1&2, 3&4 if you have two fuel lines. You just serviced it so I assume you had tank off?
I'd check for dirt in fuel line or float chambers (of course this doesnt apply if its fuel injected, but still check fuel and vacuum lines)
Did you adjust valve clearance?
2006-10-10 06:34:53 · answer #1 · answered by 1crazypj 5 · 0⤊ 0⤋
What does "serviced" mean exactly?
I agree with 1crazypj, the ignition system is probably ok if it starts again with only new plugs.
(And also his idea) it sounds most like dirt in the right-hand carbs.
What do the old plugs look like when you take them out? That is, are they crusted up black, oily black, clean and wet, dry, etc.?
Did you put too much oil in the crankcase by any chance?
2006-10-13 17:37:21 · answer #2 · answered by SLamBob 2 · 0⤊ 0⤋