I have a leaky faucet , what do I do to go about fixing it?

Answer 1

Generally it is just a case of replacing a rubber or synthetic washer. In most cases the first step is to turn off the water supply to your place. Then open the tap to drain the pipe, next you will need a wrench to undo the nut below the faucet handle. After you have done that you should then be able to unscrew the the shaft the handle is attached to. At the bottom of the shaft you sill see the washer. The washer is held in place by a short brass screw, undo this screw and pull out the washer. Insert a new one, wind the shaft back in tighten up the nut and turn on the water and you're back in business. Make sure once you have installed the shaft and tightened the nut open the tap a half turn then check to see the nut is fully tight.

Answer 2

turn your water off at the mains supply, could be under the sink ot utility cupboard area.

get two spanners/wrenches and attack the tap/faucet. Turning one wrench one way and holding the other still, until it loosens.

remove the ruber washer from within the tap/faucet and replace with a new exact copy of the dud one.

Replace tap using same method as before. If this is all too much call a plumber, it should not be expensive for this job as it will only take ten minutes and a washer is cheap.

If you are joking and the faucet you are referring to is your johnson, I suggest doing exercises to strengthen your muscles that control your urine action.

Answer 3

challenging to assist you to realize because of the fact there are this manner of excellent form of diverse form stems yet right here is going. First close the water off the two under the sink or on the optimum. Secondly open the valves (the two warm and chilly) to be sure you have the water off. subsequent eliminate the faucet handles with a screwdriver (some have caps on suitable protecting screws which you will would desire to pop off). some handles that have been on for some years would be challenging to get off, so that's beneficial to take a place in a sequence of preserve pullers. After eliminating the handles you will see a extensive nut, unscrew with pliers or crescent wrench and pull the stem out. If the stem is brass it would desire to have a rubber or plastic washer on the backside hung on by utilising a screw. eliminate screw and bypass purchase comparable length washer and replace it. If the stem is plastic then it would desire to be washerless and you purely replace the entire stem, or it would desire to have a rubber cap washers and is derived, look down in the hollow the place you pulled the stem from and see. in that case replace the cap washer and spring. Reassemble and turn water back on. solid luck

Answer 4

Obviously, you could call a plumber. Another idea would be to log onto diynetwork.com (do it yourself) to get enough information to decide whether or not it is a job you care to tackle on your own. Whatever you do, don't date or marry a plumber- you will always and forever have leaky faucets!!!

Answer 5

Today most faucets are so cheep it doesn't pay to fix them unless there swatted copper. Just turn off the water & pick up a new one from Wal-Mart. The instructions are on the package.

Answer 6

It depends on where the faucet is leaking from. Most of the time you will have to shut of the water and replace the faucet.

Answer 7

mayb the threads of the faucet have worn off, or the vicer has fallen, chk tht or fix a new faucet

Answer 8

Call a plumber.

Answer 9

give a to a plumber

Answer 10

call a plumber