English Deutsch Français Italiano Español Português 繁體中文 Bahasa Indonesia Tiếng Việt ภาษาไทย
All categories

while doing some trouble shooting i adjusted the timeing on my 85 ram mini (cargo version of the caravan) 2.6 liter figured out what the problem was which was not anything to do with the timeing.

its running very well now but i have not set it with a timeing light.even though I don't think that it is very far off from its original setting is there a chance that i could cause damage by not setting the timeing with a timeing light?

if so can you explain the steps for setting the timeing with a timeing light.

Thanks

2006-10-09 16:09:47 · 5 answers · asked by shadow765 2 in Cars & Transportation Maintenance & Repairs

5 answers

Well if you got it that close without a light then you might only be half a degree off, I would consider that very good. As far as damage is conserned, I would seriously doubt you could do anything more than nil. For setting the timing with a light, Connect the power leads with red to red and black to black and the last lead should clamp around the No. 1 plug wire, anywhere along its length between cap and plug. Then just do what you did before. It's pretty simple

2006-10-09 16:25:57 · answer #1 · answered by R.W. 3 · 0 0

You can set timing with a 12 volt trouble light if its got alligator clips. Remove the distributor cap to prevent the engine kicking over and connect the light between the positive connection to the condenser which is probably on the side of the dist. and a good ground. Turn the engine over till the timing mark lines up (maybe loosen a couple of spark plugs to make this easier) and switch on the ignition.

The points short out the light when closed so the light will be dim or out. Adjust the distributor until the trouble light just goes from dim or out to bright. Since the system throws a spark when the points just open, this is the point when the No 1 cylinder should fire. I used this system for years on a couple of different cars and when checked with workshop instruments the timing was always spot on.

2006-10-10 04:12:45 · answer #2 · answered by Anonymous · 0 0

If you take the truck for a spin when it is hot and you give it a lot of gas and you don't hear the motor pinging then you are OK!!

2006-10-09 23:28:50 · answer #3 · answered by SOLUN macedonia 3 · 0 0

So long as the engine is not idling strangely or chugging you should be fine. If you notice any of those things then you may need to recheck it.

2006-10-09 23:18:43 · answer #4 · answered by dgdkota 1 · 0 0

is it pinging? if not its probably all right :)

2006-10-09 23:12:36 · answer #5 · answered by Anonymous · 0 0

fedest.com, questions and answers