my freshley sprayed clear coat looks seedy, how do I fix?

Question

I sprayed the car (my1st timepainting a car) and the clear coat came out looking seedy after buffing???????

Answer 1

Sounds like dry spray. You were either too far away or travel speed was too fast or your gun was not set properly. The only way to fix it is to sand it with wet/dry 600 and reapply the clear. Make sure you sand every inch carefully you need to give the material something to bite to, but before you sand it you need to clean the whole car with a degreeser like PPG DX330. Automotive refinishing really isn't a job for an amateur.

Do you have a dryer on your air feed? Are you using a syphen feed or gravity feed spray gun? HVLP or Conventional? Are you regulating the air preasure at the gun or the compressor?

There really are too many variables to take into consideration when refinishing a vehicle. It may have left a "seedy" finish because you were taveling to fast, too far away, your gun was set improperly, or even your material was mixed improperly. Out side temperature can very easily play a factor.

I have been refinishing vehicles for five years and have a degree in Collision Repair Technology.

I will be posting some of my work in my photo album on my 360 if you don't believe me.

Answer 2

After the sparkling has dries for some days,with any luck contained in the daylight,start up by skill of moist sanding thoroughly with 800 grit,Then spray out the silver base coat again.This time be confident it really is skinny adequate to move out devoid of any texture or mottling.After it really is been inspected for any uneven elements,spray the clearcoat. Use a minimum of 10% reducer in it and spray at a really extreme stress, shifting quick and forcing it on to the floor in 3 coats,allowing it to tack between coats.

Answer 3

i own a repair and restoration shop,,the term your talking about is called orange peel,and it can be wet sanded out of it, if theres enough clear on it,,because it will take a layer or two off of it,but you need to start out with some 500 sand paper wet sand it then go to a higher number like 1000 grit,and sand it again,and then buff it again,,it may come out looking like a liece of glass,if you do it right ,good luck with it,i hope this help,s.

Answer 4

Wet sand the clearcoat down with 1000 grit wet-or-dry sand paper and recoat with clear if you sand through it.