I have a 94 oldsmobile achieva and the problem im having is getting the tentioner pully to go back far enough because there is only enough room to get a wrench on there because its right by the frame in front.... so what is the trick or what do i use to get the tentioner to go back far enough so i can get the new belt on there.... the old one came off just fine i had to replace it because the whole edge was completely frayed and it wasnt chargeing all the way because the belt was so bad....
2006-10-04 14:25:23 · 6 answers · asked by chvyracn_24 2 in Cars & Transportation ➔ Maintenance & Repairs
Make sure that you have the belt routed the right way 1st. Have a friend help and try this, instead of trying to get the belt over the tensioner, route the belt on the tensior and while you pull on the tensioner, your friend pulls the belt over another pulley i.e. the altenator,p/s, etc.
2006-10-08 12:34:40 · answer #1 · answered by nate_625 3 · 0⤊ 0⤋
94 Oldsmobile Achieva
2016-11-04 04:28:07 · answer #2 · answered by ? 4 · 0⤊ 0⤋
I am pretty sure that Lisle tools makes a special wrench designed for just such a problem. If you have access to a torch, you might take a long box end in the right size and bend the head a bit. Stick a pipe on it an reef.
2006-10-04 15:45:39 · answer #3 · answered by united9198 7 · 0⤊ 0⤋
There are diverse flasher instruments for the turn alerts and the emergency flashers. they're regularly in the fuse container and are round. activate thee emergency flashers and make contact with each and every of th instruments. the only it quite is ticking isn't the only you want so replace the different one. In some GM autos, the flashers were placed contained in the decrease middle sprint fairly. As for the reflect, i tried it again after taking somewhat sand paper to bot the block and the window to not elementary it up somewhat and that develop into 5 years in the past and has no longer come down yet. also, take the block out of the reflect in case you have not already and enable the block dry through itself on the window for twenty-four hrs only for good degree earlier attaching the reflect
2016-12-04 06:57:49 · answer #4 · answered by ? 4 · 0⤊ 0⤋
those are a real bit#$ to get back on you need sum patience and you will get but it dont hurt to have a friend help you when you get tensioner back to have him slipp belt on pulley
2006-10-04 14:32:49 · answer #5 · answered by bowhunter6778 2 · 0⤊ 0⤋
3/8 inch wrtetchet or half inch drive and really yank it back...HARD...lots of tension on that spring
2006-10-04 14:28:21 · answer #6 · answered by stephy0923 2 · 0⤊ 0⤋