How do you make a home made sensor for detecting clones?

Question

Look at these aliens go to extrems to hide them sleves and pretend their human its a all day chore for them then they finaly admit it when there lowering you into a shallow grave that there not human and they are from some clone facility. so how do you make a detector to recognize them?

Answer 1

You need to gather these materials

4 inches of RED wire
10 inches of BLUE wire
2 AA Batteries
6 AAA Batteries
A Sponge
A Jellyfish
A Spoon
Squirty glue
AND A TURNIP!!!

First you make sure your jellyfish is dead. (be sure to wear gloves) Hollow out your turnip and place the batteries inside enough salty water to cover them place the sponge on top of this. Interwind your wires with the RED ends being 3inches away from both the BLUE ends bend it like a "U", drive the ends through the centre of the sponge into the battery solution. Now use the squirty glue to seal the sponge into the turnip so that it can't move. place your jellyfish and spoon on top of the sponge and wrap the whole thing in film making sure the hole at the top of your turnip is covered and sealed with only one layer.

So what should happen if someone who is a clone walks by the batteries will become charged because of their advanced brainwaves and send a current through the wires which will cause them to become an electro magnet which will try to pull the spoon through the sponge and squash the jellyfish at the same time pushing all of its light emmiting particles to the outer layer of it's skin that will emit an eerie but intense glow therefore signalling a clone. SIMPLE, great when used for detection of trick or treater clones hehehehe.

Answer 2

Cover your head in silver foil. If, when you walk down the street, they don't laugh and point, they are alien clones.

Answer 3

well what did the voices in your head have to say about this?

Answer 4

Wow, a little paranoid are we???? Take your medicine again & it will be alright...