No spare keys, he just got out and it was locked with keys still in there.
2006-09-30 00:21:54 · 15 answers · asked by sillybee 1 in Cars & Transportation ➔ Maintenance & Repairs
another version of the coat hanger trick is get a piece of sring make a ' u ' and get a stiff piece of card make it heavy (ish by taping a pound coin to it. ) pu two holes in it about 5mm from the top and a bit narrower of the pull up button, thread string over the top of door and loop over the button once done put the card throughgently pull and it should noose the button thus pulling it up. good luck
2006-10-03 11:56:29 · answer #1 · answered by TERRY READ 4 · 0⤊ 0⤋
The old coat hanger trick. Get a wire coat hanger and some pliers . Cut the hook part off the coat hanger and straighten the wire. Use some needle nose pliers and bend a small hook on the end of the wire.Work the wire in between the door and frame using a flat pry bar to make the crack bigger.Be careful with that paint and rubber weather stripping.Hook the door latch and open the door.
2006-09-30 00:27:57 · answer #2 · answered by super stud 4 · 0⤊ 1⤋
Please note ref withering's answer - if your car has side airbags do NOT poke around under the weather strip. A coat hanger down the top of the door to the pull button will work fine, Get the coat hanger sliding down the glass with the hook pointing at the other side, with the hook bent at the right angle it will wedge itself between the glass and the button making it easier to pull up.
2006-09-30 07:50:47 · answer #3 · answered by Tom 2 · 0⤊ 0⤋
contained in the door panel there's a c clip that holds the major cylynder contained in the door. It has probable fallen off. in case you could not locate it contained in the bottom door it really is an inexpensive section to purchase. The c clip is bent in order to carry stress hostile to the door. Junk yards will understand what you're speaking about in case you assert you want a lock cylinder clip for a cherokee.
2016-11-25 03:44:56 · answer #4 · answered by roedel 3 · 0⤊ 0⤋
If your a tripple A member, they'll come out and open it for free, otherwise, you could call your local police department they may or may not come out and unlock it for ya. Or, call a locksmith, depending on the time it takes for him to open it, it could cost between $35.00 and $75.00. Why don't he try using a hanger first, if that doesn't work, or if it's going to ruin the paint or anything, call the locksmith or local police and explain.
2006-09-30 00:27:29 · answer #5 · answered by Anonymous · 1⤊ 1⤋
Thank you for giving us the make AND model of the car, that will make a big difference in the solution.
Put a magnet up to the windshield and try to attract the keys.
2006-09-30 00:25:20 · answer #6 · answered by Anonymous · 0⤊ 2⤋
remove the outer ruber rain cover.
take a cote hanger put down window & feel for a latch then ,
depends on modle lift or pull back
2006-09-30 05:39:33 · answer #7 · answered by witheringtonkeith 5 · 0⤊ 0⤋
try calling a Chrysler-Jeep dealer, with the vehicle vin (serial number) they may be able to make a key (I know General Motors can)
2006-09-30 01:50:24 · answer #8 · answered by KMU 3 · 1⤊ 1⤋
motor assistance organisations would be your best bet (AA, RAC, Green Flag), failing that try asking the police (they may help, or they may be able to give you some pointers of who could unlock it
failing that look out for a chavster, with the trademark baseball hat & slack jawed look - they seem to be able to break into cars in seconds with no damage
2006-09-30 00:32:05 · answer #9 · answered by Mark J 7 · 0⤊ 2⤋
Get a locksmith! I cannot assure they are going to fix it totally but they are likely to.
2006-09-30 00:48:45 · answer #10 · answered by mattied23 3 · 0⤊ 1⤋