2006-09-27 13:01:21 · 5 answers · asked by ? 1 in Cars & Transportation ➔ Maintenance & Repairs
Start with fuel filter first, check air filter, lines could be plugged with crap (I have seen this before), could even be bad fuel
2006-09-27 13:35:27 · answer #1 · answered by nbr660 6 · 0⤊ 0⤋
Is it diesel or gas? if it's diesel then replace the fuel filter and clean the air filter. Be sure to fill the fuel filter with fuel before installing. If it's gas..the same as above...however depending on the year it may have a setiment bowl in addition to/ rather than a filter. Clean the setiment bowl and the air filter and it should run ok.
2006-09-27 13:06:03 · answer #2 · answered by Kenneth S 5 · 0⤊ 0⤋
You the two have air in the gas injector lines which may be bled by utilising cracking each injector open one after the other until finally not something yet gas runs out of it and tightening it back up. There additionally could be a bleeder screw at or approximately the place the gas clear out is or the primer pump. The primer pump often appears like somewhat plunger. If there's a a small bolt close to it you are able to crack it open and bleed it there. Crack the lines open one at atime on the gas injection pump 1st then flow to the injectors and repeat the technique in case you discovered air on the bleeder valve. there is likewise often a water separator that catches water in the gas and separates it from the gas. there'll be a drain bolt on the backside of that too. be certain all of the water is drained out if that section.Water in the gas ought to reason that concern too. And the separator can recover from finished with water and nonetheless feed water on your engines gas lines. a sturdy thank you to scrub the injectors after all this has been tried or discovered is to alter the gas clear out.Fill the hot gas clear out up with confident believe it or not ATF computerized trans challenge fluid. It cleans and lubricates the injectors So your finding at.....A wrench to crack open injector lines one by utilising one commencing with the gas injection pump,then the connectors on the gas injectors,and a quart of ATF. that could desire to be all you want until the gas device is sucking in air someplace else. And draining the water out of the gas water separator. not plenty money contain in any respect. purely be certain that something you crack loose is tight once you finished and not leaking. be certain your air air purifier isn't clogged all to hell too
2016-12-15 15:45:21 · answer #3 · answered by karg 4 · 0⤊ 0⤋
Diesel or gas engine? Injector/pump problem? Carb problem? Fuel supply problem....? Need more info.
2006-09-27 13:04:15 · answer #4 · answered by Anonymous · 0⤊ 0⤋
what type fuel..diesel/gas/lp..lots of things it could....really need to know what type fuel. Could run from injectors,fuel filters..fuel pump... sorry not enough info..repost it.
2006-09-27 13:13:18 · answer #5 · answered by ? 6 · 0⤊ 0⤋