I have a 99 GMC Sierra, sometimes it wont start but then after a few minutes it will. They told me it is the passlock system cause the SECURITY light stays on while I drive. The system is around $600 to fix, does anyone know how to disengage it without spending alot of cash?
2006-09-26 08:18:13 · 4 answers · asked by rudy c 2 in Cars & Transportation ➔ Maintenance & Repairs
Before coughing up the 600 bucks, there is a bulletin from GM on your truck that applies to the pass-lock system. It involves soldering the wires to the terminals for the pass-lock system. The wires become loose and a poor connection is the result. The fix is to solder these terminals to there respective wires. I believe this is the condition you are encountering.
Stop back into the dealer and give them this bulletin number; #01-08-56-002A
Security Lamp Illuminated on the IP, Engine Stalls, No Start, DTC B2960 (Security System Sensor Data Incorrect but Valid) Set (Inspect and Repair Cause of DTC B2960) #01-08-56-002A - (06/19/2001)
2006-09-26 16:16:02 · answer #1 · answered by knowsitall1 2 · 0⤊ 0⤋
sometimes the fix to your problem is a replacement PASSLOCK sensor which is located in your key cylinder casing. get a second opinion at a gm dealer. the replacement should not cost near that much!
2006-09-26 20:35:24 · answer #2 · answered by Todd V 2 · 1⤊ 0⤋
Welcome to General Motors.
Your solution is to cough up the $600 and plan on spending more.
2006-09-26 15:23:38 · answer #3 · answered by Stumpy 4 · 0⤊ 2⤋
call a locksmith they can also do it
2006-09-26 18:02:59 · answer #4 · answered by Stan 3 · 0⤊ 1⤋