DOES ANYONE KNOW THE STEPS TO CHANGE FRONT TRANNY SEAL ON A 1990 FORD F150 4x4 302 V8?

Question

NEED THE STEPS TO REPLACE FRONT SEAL AND ESTIMATED TIME TO REPLACE IT THANKS

Answer 1

You have to pull the tranny to do it. NO other way possible! Best way is the Chilton's available at most auto parts store otherwise I'll be here all day on this one question. As far as time is concerned, you are an ameteur so plan on the better part of an entire longgggggggggggggggggggg day!

Answer 2

Start by placing the truck on high jack stands or a hydraulic lift. Drain the trans/transfer case oil and remove the drive shafts. Remove the rear frame cross member. Remove the bolts holding the transmission/transfer case. Lower the unit using a transmission jack. Remove the input shaft cover and seal. Replace the seal and reassemble in reverse order. Refill the trans/transfer case. Time required about six to eight hours.

Answer 3

hydraulic lifters are like little pump up ask your self absorbers. They place self belief in being packed with oil to pump up and not click. in the event that they're clicking, they at the instant are not getting sufficient oil rigidity interior. the familiar concern is gunk from grimy engine oil blocking off up the little holes that enable oil into them. Any of the gunk cleansing fluids in vehicle shops ought to restoration that. yet bear in mind that a sturdy solvent like that which could consume gunk might consume different issues ( like rubber seals ). study the label intently. yet another concern could be that they are wiped out previous restoration and could be replaced. Lifters are not very costly. yet you need to get the valley conceal off to get at them in a V8. as quickly as the frenzy rods are out, you are able to pull the lifters out by utilising making a hook in the top of somewhat spring steel twine, get the hook into the little oil hollow in the dish formed precise of the lifter and pull it out. Taking aside a gas injected engine is as elementary as a carby engine. purely ensure you're taking the injection stuff off in as massive a sections as you are able to so as that it somewhat is elementary to reassemble. be certain all of the sensors are appropriate plugged back in and take a heap of photograph's alongside with your digicam in the previous you strip it.