I obtained this router from scrap. Im using hyperterminal to access it . The router boots but it prompts me to enter a password which I dont know. I read some documentation from cisco systems where they explain a process but I am not getting a command prompt to enter the commands explained in the documentation
2006-09-24 13:18:50 · 3 answers · asked by show 2 in Computers & Internet ➔ Computer Networking
Maybe your version of HyperTerminal is not sending the break character, not that you may have to press ctrl-break. With hyperterminal up an running while connected to the console port, power up the router and after a few seconds press Ctrl-Break and at the rommon prompt, type "confreg 0x142" and then "reset". Now, if it asks you to run a config utility, just type no and hit enter. Then type "enable" and then "conf term" and then "enable secret xxxx" where xxxx is your password. Then type "config-reg 0x2102" and then hit Ctrl-Z and type "copy run start" and then "reset" one more time.
2006-09-24 14:58:54 · answer #1 · answered by networkmaster 5 · 1⤊ 0⤋
Is this the page you were reading?
http://www.cisco.com/en/US/products/hw/routers/ps221/products_installation_guide_chapter09186a008007e57a.html#wp1022331
Click on resetting the router.
That should work.
2006-09-24 20:37:21 · answer #2 · answered by jjacy123 3 · 0⤊ 0⤋
for the id user type: administrator
for the pasword type: password
if u will have another problem, just tell me.
2006-09-24 20:31:11 · answer #3 · answered by Alex S 2 · 0⤊ 1⤋