i have packer bell computer i forgot the password?

Question

it as no user names is a 92

Answer 1

You may have to reinstall the operating system. Are there any other user accounts on the computer for which you know the password? What operating system is it?

Answer 2

Fortunately, Microsoft has included several backdoors to solving this problem.... unfortunately, hackers sometimes use it too....
*******
>Make sure that you have a keyboard that plugs into your MOUSE port (green) on the back of your PC. USB will not work!
>Turn on your computer
>Repeatedly press F8 (really fast) until a screen filled with words appears (if this doesn't work, you stopped pressing it too early.... start over, but keep pressing it until you get to a screen that has lots of options on it)
>Using the arrow keys, select 'Safe Mode'
>Press 'enter'
>Your computer may start with a different resolution (screen size) than you're used to... that's OK
>If you have Win XP w/ welcome screen, click on "Administrator"
>If you have a username / password box, type: "administrator" in the 'username' box, and click 'OK' (no password)
>This should let you log onto your computer without a password.
>After everything loads, click 'start'
>Go to the 'control panel' (hopefully, you know how to do this)
>Go to 'user accounts'
>Click your account (or the one needing a password reset)
>Change the password
*******
Now you should be done. Close everything and restart your computer normally. Log onto your account using your new password
*******
NOTE: It wouldn't be a waste of time to create a 'password recovery disk' (you need a floppy disk drive) For instructions on a 'password reset disk', go to the help & support section of your computer.

I hope this helps

GOOD LUCK!

Answer 3

http://forum.packardbell.com/en/viewtopic.php?t=42319&sid=7b22ca9b558586899bcf0cfd6ae7aed7

Password Clear (J9C1-D)
http://www.uktsupport.co.uk/pb/mb/760.htm
This jumper is for clearing the password if the password is forgotten. The default setting is pins 2-3, (password enabled). To clear the password, turn off the computer, move the jumper to pins 1-2, and turn on the computer. Then turn off the computer, and return the jumper to pins 2-3 to restore normal operation. If the jumper is in the 1-2 position (password disabled), you cannot set a password.

Answer 4

this is a good one. You might need to call customer service, or restar the manufacture settings (this is a little complecated and it takes a long time, that is why it is better to contact customer service).

Answer 5

http://pubs.logicalexpressions.com/pub0009/LPMArticle.asp?ID=305