2006-09-21 16:15:19 · 9 answers · asked by Anonymous in Cars & Transportation ➔ Boats & Boating
Dragging through the sand works well.
2006-09-22 11:58:55 · answer #1 · answered by exert-7 7 · 0⤊ 0⤋
If the boat is trailer able there are a number of different things you can use depending on how thick the growth is, from a trowel to a hard sponge. If it is in the water, beach it then as the tide goes out use a plastic bondo applicator to break the growth loose and then when the tide comes in back out and do it again later until you have knocked off what you can from the beach, then get a mask and snorkel and finish the job for the areas you could not get from the beach. Remember the lighter the growth the softer the “tool” you use but stay away from anything that can cut or scrape the boat hull.
2006-09-22 17:02:24 · answer #2 · answered by george m 3 · 0⤊ 0⤋
Begin with a power washer. Then a wide putty knife scraper. To get bottom paint off we used Peel Away. It still required more scraping. Use a palm sander.
2006-09-25 18:08:44 · answer #3 · answered by science teacher 7 · 0⤊ 0⤋
Paint scrapers, industrial soap and water, CLR maybe, The brown type of scrub pads you'd use to cleen a grill. Lots of elbow grease.
2006-09-23 04:06:34 · answer #4 · answered by Cactus Dan 3 · 0⤊ 0⤋
TOOLS???? Good GAWD!!! Don't even think of using tools...unless there's an awfully stubborn crusty deposit, then I might suggest a hammer and chisel!
2006-09-21 23:25:58 · answer #5 · answered by Lord Cif 2 · 0⤊ 0⤋
pressure washer,wide putty knife,side grinder for hi speed wirebrushing of prop and rudder,six pack on ice
2006-09-22 00:00:18 · answer #6 · answered by Bushit 4 · 1⤊ 0⤋
Hydrochloric Acid. (THE WORKS Toilet bowl cleaner),,,..rubber gloves,,, Eye protection
2006-09-25 12:50:24 · answer #7 · answered by frank26694 3 · 0⤊ 0⤋
Baby wipes..
2006-09-21 23:22:49 · answer #8 · answered by Anonymous · 0⤊ 0⤋
wipes
2006-09-21 23:23:17 · answer #9 · answered by Lee J 4 · 0⤊ 0⤋