English Deutsch Français Italiano Español Português 繁體中文 Bahasa Indonesia Tiếng Việt ภาษาไทย
All categories

3 answers

The Big wire goes to the fat stud on the starter soleniod. The small wire goes on the small stud on the starter soleniod labled IGN "ignition", It may have a blade type connector or slips on the stud with a small nut holding it on. The big wire is from the battery.....Make sure you disconnect the negative cable on your battery before you even touch anything or else you'll see fireworks under your car. If you remove one nut pull the wires off and tape them together, Remove another nut and tape those wires together if there is more than one from each stud. This will help avoid confusion when figuring what wire goes where when you put it back together. You will probably need a ratchet and a few different sized extentions,and a swivel or universal joint to get the bolts out.

2006-09-25 12:12:04 · answer #1 · answered by whtsthislif4 5 · 0 0

the smaller purple one go on the small stud toward the inside 8mm or 10mm , the very lagr wire and possibly a group of two wrire together go on the larger stud 13mm or 14mm nut

2006-09-21 12:37:59 · answer #2 · answered by fordmanjay 1 · 1 0

one is direct to the battery another is to the starter switch*the key* and the starter is grounded out thru the bolts to the motor.

2006-09-21 12:21:25 · answer #3 · answered by chevytruckdood 2 · 0 0

fedest.com, questions and answers