Wood burning stove?

Question

What size elbow goes on the back of the older fisher mama bear free standing wood stove, and does it go inside or outside of the cast iron pipe on the back?
Thanks.

Answer 1

The wood stove pipe goes over the outside.

Instead of an elbow, we used a clean-out T.
picture your woodstove pipe coming down from the ceiling, and joining at an intersection to your woodstove. The "T" can be opened up at the back and easily cleaned without tearing up your pipe.

You can get these are your local woodstove or hardware store.

Good Luck!

Answer 2

the old fisher stoves have an 8" vent and the pipe or elbow usually fits over the collar (cast iron pipe on the back) The problem is that the crimped end of the pipes should be facing down to prevent creosote from leaking on the outside of the pipe. the factory crimp usually does not fit inside the collar. being in the chimney biz, i have a crimping tool that makes the crimped end smaller so that it fits inside the collar.

Answer 3

It goes over the out side and they are usually six inches in diameter which is the standard size and it usually is a 90 degree elbow that attaches to the stove.

Answer 4

You need to measure it. I would say a six inch though. Generally the elbow go on the inside of the cast iron ring.

Answer 5

It, of course, goes on the inside of the stove on the back side... When we had one, we used a 45 degree angled elbow on the back

Answer 6

the clever answer can purely take transport of with the scale of your place and placement of timber burning range.... timber stoves have not any thermostats,,, so in the adventure that your paying for timber interior the tip you ll unfastened money an focus your warmth in a single area... critical warmth is controlled a superb yet once you have a unfastened timber source go timber until eventually it runs out in the present day of year its all with regard to the $$$$$

Answer 7

measure the opening from outside edge to outside edge.It goes outside.Check with your homeowners insurance before firing it up.If you don't notify them you aren't covered.You might want to get the manual from the company as well.There are several other safety features you need to know.

Answer 8

you have to measure the opening to get the diameter. they usually go over the outside.