i have a 1990 toyota camry.it has automatic seatbelts...driver side wont work but the passenger side does????

Answer 1

HATE THOSE THINGS
THE USUAL PROBLEM IS IN THE DRIVE GEARS AND ROPE GEAR IN THE DOOR
IT IS SORT OF A NYLON CORD WITH TEETH THAT MOVES THE SEATBELT WHEN THE DRIVE MOTOR IS ACTUATED
THE TEND TO WEAR OUT AND WONT WORK
IT IS MUCH THE SAME AS WHAT MAKES A POWER ANTENNA GO UP AND DOWN
SINCE YOUR BROKEN ONE IS ON THE DRIVERS SIDE WHICH GETS USED ALL THE TIME IT IS APT TO WEAR THE NYLON TEETH OUT FASTER THAN THE PASSENGER SIDE
THE PART IS USUALLY ONLY AVAILABLE THROUGH THE DEALER SO DONT WASTE TIME WITH NORMAL PARTS STORES
THEY CAN GIVE YOU A PICTURE OF WHERE IT GOES AND YOU SHOULD BE ABLE TO INSTALL IT YOURSELF WITOUT TOO TOO MUCH TROUBLE

Answer 2

achievable motives: a million. make valuable the floor is dry then tension for a at the same time as with the a/c on, then permit it sit down for a couple of minutes when you turn it off. If the floor is moist then it ought to be the a/c. 2. examine under the motor vehicle to make valuable there are no holes interior the floor (comparable subject in a toyota celica). 3. front windscreen seal or door seal has a leak (comparable subject in ford truck) 4. make valuable the coolant is done then run the motor vehicle till it is heat and run the heater then the defrost. in case you scent something or see any liquid dripping then possibly it is your heater coil (comparable subject in olds). 5. final, yet hopefully not the priority, if the liquid has a rather oily experience that is brake fluid from the cylinder related to the brake pedal or the grasp pedal(additionally comparable subject in toyota celica). desire this enables. j.m.

Answer 3

The little motor that moves the seat belts is broken. It needs to be replaced. I recommend checking the fuse before replacing, but the seat belt motor does eventually wear out and the car's 16 years old.