2006-09-18 14:33:05 · 5 answers · asked by Anonymous in Home & Garden ➔ Do It Yourself (DIY)
Use your template and mark all you boards with your design. Then use wood blade and 'jig saw' and cut away. The more twisting the design, the less width the blade needs to be. Usually 1/4" wide. Not that hard once you get your 'rhythm'. Do it like an assembly line. Have fun with your project.
Exert about blades from site below:
One of the most important parts of the saw is the blade. Different blades are available for different applications. Blades are classified by the number of teeth they have per inch (tpi). The higher the tpi the smoother the finished cut. The lower the tpi the quicker the cut. The material from which the blade is made also effects performance. Here are a few common blades and their uses:
High Speed Steel (HSS) blades are usually used for wood and light metal cutting.
Bi-metal blades are used for wood and light metal cutting.
Cobalt steel blades are harder than HSS or bi-metal blades and should last longer. They are commonly used for wood and metal cutting.
Carbide grit blades are used to cut masonry board.
Scrolling blades are narrower than typical jig saw blades and used to make tighter turning cuts.
2006-09-18 15:01:58 · answer #1 · answered by Anonymous · 0⤊ 0⤋
Scroll saw, jig saw coping saw ( the last is manual and the most accurate). No blades over 14 teeth per inch. Also take into consideration the moisture content of the wood. Wet wood gums up the teeth of finer blades taking longer and burns the blades out. Cut on the outside of the line then use a fine wood file to clean up the cuts. Good Luck and have fun
2006-09-18 16:44:44 · answer #2 · answered by carpenterslavemoney 5 · 0⤊ 0⤋
Use Bosch jig saw with special blades available specially for lumber.
2016-03-17 22:41:00 · answer #3 · answered by Anonymous · 0⤊ 0⤋
Yep, I gotta agree with number 2. Whatever are you asking?
Are you attempting decorative grooving? What is your definition of a "Simple Scroll"???
More detail perhaps, and better answers. IE: Yahoo even suggests that.
What possible difference does it make what the lumber is? Treated or not.
Simple Cuts,,,Chop saw. Rip cuts,,,Table saw,,,or iffy cutting, a skil saw. Scroll work,,,detailing,,, a router, or roto zip.
Rev. Steven
2006-09-18 16:11:22 · answer #4 · answered by DIY Doc 7 · 0⤊ 0⤋
The Question doesn't make any sense. How about more details. 30 cuts doesn't sound like a simple scroll. What are you talking about?
2006-09-18 14:46:48 · answer #5 · answered by Anonymous · 0⤊ 0⤋
circular saw or chop saw . wood blade i use
2006-09-18 14:41:24 · answer #6 · answered by chris c 3 · 0⤊ 0⤋