2006-09-18 07:46:28 · 5 answers · asked by Anonymous in Home & Garden ➔ Maintenance & Repairs
either u replaced with another bad valve or u do have excess pressure. only way u should have too much pressure is if the water is way heated more than it should be. that would be obvious, so if u aren't seeing that then replace the valve again.
u could also try opening the valve and let it snap back down... that might make it seal if it's stuck partly open.
2006-09-18 07:48:53 · answer #1 · answered by Roger 4 · 0⤊ 0⤋
If the second PRV also lets off pressure then you have issues with your water heater. What temperature is it set at? Is it set to the max? One thing you DO NOT want is for the water heater to be allowed to boil. The explosions from that happening are stuff that makes front page news. You might consider a replacement water heater if the settings are correct.
2006-09-18 11:44:35 · answer #2 · answered by daveduncan40 6 · 0⤊ 0⤋
Before replacement there is probably sediment on the valve seat that is keeping it from closing fully.
After (if the right pressure setting was chosen for the new one) you might still have some sediment that you need to flush out.
2006-09-18 07:50:04 · answer #3 · answered by Rich Z 7 · 0⤊ 0⤋
that you will be able to simplest finally end up to be king of the English if that you'll educate your blood-line going back to King David at Jerusalem. the completed English Medieval Kings necessary to educate their better 1/2 and toddlers connection with the Royal position of abode of King David. Even Jesus Christ had an analogous connection, otherwise the English ought to no longer imagine in him. The effective King David of Israel - slayer of Goliath the monster of the Philistines.
2016-11-27 22:25:58 · answer #4 · answered by ? 4 · 0⤊ 0⤋
heat expands. is the first reason . the old heater is damaged from hard water . and the other reason is improper re-installment by that idiot handyman
2006-09-18 07:56:51 · answer #5 · answered by pahump1@verizon.net 4 · 0⤊ 1⤋