There are a couple ways to do it. The easiest is take the skinny end put it about six inches below your collar. wrap the fat end around the skinny end twice. Then pull the fat end through the opening near your collar. Now put the fat end through the second loop you made when wrapping it at first. Pull it through and check for length. If it is too long or too short adjust the starting point of the skinny end and start over. It should end at about belt level.
2006-09-16 07:13:28
·
answer #1
·
answered by M.B. 4
·
0⤊
0⤋
Here is how to tie a Windsor Knot
The Windsor Knot is a thick, wide and triangular tie knot that projects confidence. It would therefore be your knot of choice for presentations, job interviews, courtroom appearances etc. It is best suited for spread collar shirts and it's actually quite easy to do.
While just about everyone can use this tie knot to tie his tie, it looks especially well on men with longer necks as its wide form shortens the perceived height of the neck a little bit.
To tie the Windsor Knot, select a tie of your choice and stand in front of a mirror. Then simply follow the steps below:
1) The wide end "W" should extend about 12 inches below the narrow end "N". Cross the wide end "W" over the narrow end "N".
2) Bring the wide end "W" up through the loop between the collar and your tie; then back down.
3) Pull the wide end "W" underneath the narrow end "N" and to the right, back through the loop and to the right again so that the wide end "W" is inside out.
4) Bring the wide end "W" across the front from right to left.
5) Pull the wide end "W" up through the loop again.
6) Bring the wide end "W" down through the knot in front.
7) Using both hands, tighten the knot carefully and draw it up to the collar.
Congratulations, you did it! You see, it is not rocket science after all. Simply keep practicing the Windsor Knot a few more times until you can tie this necktie knot within less than 30 seconds.
2006-09-16 07:19:53
·
answer #2
·
answered by An Unhappy Yahoo User 4
·
0⤊
0⤋
Go to www.tieguide.com/windsor.htm and you will find an illustrated, step by step, guide on how to tie a Windsor Knot.
2006-09-16 07:18:33
·
answer #3
·
answered by ijcoffin 6
·
0⤊
0⤋
HI,,,,,, put tie on,,,, small side on left, big side right,, right a longer around the neck, take right over left,, around up and under the neck, and thru the loop,, and tighten to suit yourself....
Once he does it a few times it will come back to him,,,,,
good luck
2006-09-16 07:19:14
·
answer #4
·
answered by eejonesaux 6
·
0⤊
0⤋
here are instructions for a Windsor, Half Windsor, Four-in-Hand and bow tie knots.
2006-09-16 07:19:29
·
answer #5
·
answered by h2odog 3
·
0⤊
0⤋