is it difficult to remove tranny from a 91 chevy camaro rs anyone know of a good site where the instruct you on how to remove tranny
2006-09-13 17:24:29 · 5 answers · asked by Anonymous in Cars & Transportation ➔ Maintenance & Repairs
This isn't something you want to attempt with 'net instructions.
Go to the parts house and buy the repair manual for the little car, and read the procedure. They read it again. In fact, read it over and over to yourself until you know it.
Then, go out and raise the car, and read it again, looking at what you are about to do.
This will be a whole lot more help to you particularly after you get into it, and find that you have a question, or think you might have done something wrong.
BTW----Use 4 jack-stands. DO NOT work under the vehicle on a jack or floor jack.
God hates a coward, but He hasn't much use for those who won't use the good sense He gave them.
Good Luck
2006-09-13 17:33:09 · answer #1 · answered by Ironhand 6 · 0⤊ 0⤋
Most typical rear drive cars' removal of the transmission is the same. In a rough outline..
Drain the transmission of the oil.
You have to remove the drive shaft first. Press or unbolt the u-joint at the rear axle. With this removed you can slide the drive shaft out of the transmission. The drive shaft has a geared cylinder on the transmission end that slips on the transmission.
With the drive shaft removed, you put a jack under the tranny to hold it's position. This is very important to make stable. You may want to support the transmission in to places or more to stablize it.
Then with the transmission supported, unbolt it from the engine block. Disconnect the oil lines, speedometer lines, cooling lines, etc. It should then slide out.
The torque converter will be on the transmission side when you slide it out so watch out for that.
2006-09-14 00:30:38 · answer #2 · answered by hocky_06 3 · 0⤊ 0⤋
Automatic or standard? Either one it's pretty simple. Go to your local Advance auto or Auto Zone and get one of the repair manuals which instruct you step by step! Automatic or standard you need to pull the bell housing bolts, and the automatic requires the flex plate bolts also be removed. Of course drive train, tranny mount bolts etc. Not to difficult but rather tight area to work on the camaros.
2006-09-17 21:04:19 · answer #3 · answered by Anonymous · 0⤊ 0⤋
no it not that hard at all however iv been doing this for 12 yrs. the best thing to do is to get a Chilton's Manuel from an auto parts store or the library it would take about 3 to 5 hrs to remove it
2006-09-14 00:28:59 · answer #4 · answered by ? 2 · 0⤊ 0⤋
you did not say if your camaro is an automatic or standerd
2006-09-14 10:47:56 · answer #5 · answered by polaris lover 1 · 0⤊ 0⤋