Tectonic plates
The earthquake was unusually large in geographical extent. An estimated 1,200 km (750 mi) of faultline slipped about 15 m (50 ft) along the subduction zone where the India Plate dives under the Burma Plate. The slip did not happen instantaneously but took place in two phases over a period of several minutes. Seismographic and acoustic data indicate that the first phase involved the formation of a rupture about 400 km (250 mi) long and 100 km (60 mi) wide, located 30 km (19 mi) beneath the sea bed—the longest rupture ever known to have been caused by an earthquake. The rupture proceeded at a speed of about 2.8 km/s (1.7 mi/s) or 10,000 km/h (6,300 mph), beginning off the coast of Aceh and proceeding north-westerly over a period of about 100 seconds. A pause of about another 100 seconds took place before the rupture continued northwards towards the Andaman and Nicobar Islands. However, the northern rupture occurred more slowly than in the south, at about 2.1 km/s (1.3 mi/s) or 7,600 km/h (4,700 mph), continuing north for another five minutes to a plate boundary where the fault changes from subduction to strike-slip (the two plates push past one another in opposite directions). This reduced the speed of the water displacement and so reducing the size of the tsunami that hit the northern part of the Indian Ocean.[7]
The India Plate is part of the great Indo-Australian Plate, which underlies the Indian Ocean and Bay of Bengal, and is drifting north-east at an average of 6 cm/year (2 inches per year). The India Plate meets the Burma Plate (which is considered a portion of the great Eurasian Plate) at the Sunda Trench. At this point the India Plate subducts beneath the Burma Plate, which carries the Nicobar Islands, the Andaman Islands and northern Sumatra. The India Plate slips deeper and deeper beneath the Burma Plate until the increasing temperature and pressure drive volatiles out of the subducting plate. These volatiles rise into the crust above and trigger melt which exits the earth's crust through volcanoes in the form of a volcanic arc. The volcanic activity that results as the Indo-Australian plate subducts the Eurasian plate has created the Sunda Arc.
As well as the sideways movement between the plates, the sea bed is estimated to have risen by several metres, displacing an estimated 30 km³ (7 cu mi) of water and triggering devastating tsunami waves. The waves did not originate from a point source, as mistakenly depicted in some illustrations of their spread, but radiated outwards along the entire 1,200 km (750 mi) length of the rupture (acting as a line source). This greatly increased the geographical area over which the waves were observed, reaching as far as Mexico, Chile and the Arctic. The raising of the sea bed significantly reduced the capacity of the Indian Ocean, producing a permanent rise in the global sea level by an estimated 0.1 mm.[8]
ETA: I'm ROFL that someone gave this answer a thumbs down, given that it not only answered the question completely, but gave additional info - some people just can't handle someone else having a more complete answer, I guess - LOL!
2006-09-12 12:52:56
·
answer #2
·
answered by tagi_65 5
·
2⤊
1⤋
The earthquake was the result of the sliding of the portion of the Earth's crust known as the India plate under the section called the Burma plate.
2006-09-12 12:57:24
·
answer #3
·
answered by Chug-a-Lug 7
·
2⤊
0⤋