engine has no power to idle position sensor or the egr. At idle runs a little rough, a real rough when in gear, has no power when taking off.
2006-09-08 11:54:31 · 4 answers · asked by honyoc88 1 in Cars & Transportation ➔ Maintenance & Repairs
When you swapped the engine did you bring the computer along with it?
2006-09-08 11:57:12 · answer #1 · answered by Joe K 6 · 0⤊ 0⤋
Try removing the EGR valve and cleaning it out. Fords were notorious for EGR problems. Remove the valve and bang it flat side down on a hard surface or with a hand vacuum supply pump open the valve and spray some throttle body cleaner inside the pintle and seat area and let it sit for a few minutes and then reinstall the valve and that might help.
2006-09-08 12:03:36 · answer #2 · answered by Iknowthisone 7 · 0⤊ 0⤋
Has a break in the wire somewhere between the computer and the sensor. Check your other connections first. before tracing each wire. Sometimes is possible a pin can get pushed back in the connector, causing the no signal. Hope this helps.
2006-09-08 11:57:33 · answer #3 · answered by Silverstang 7 · 0⤊ 0⤋
replace plugs roto cap and button and if it has points then replace them, and then again it could have a bad valve
2006-09-08 12:35:26 · answer #4 · answered by dustin b 1 · 0⤊ 0⤋