what kind of paint do I buy to re-glaze a bathtub?

Answer 1

There are expoxy-based tub refinishing paints kits that you can purchase, or have another person apply for you. They are durable enough for a few years, but nowhere as tough as the original baked-on porcelain finish.

You need to clean the existing surface very, well of all soap scum, dirt, oil, etc then clean with alcohol. And possibly fill in any chips or nicks. Then you either roll or spray the epoxy paint over the entire tub and let it dry for at least 24 hours with excellent ventilation.

People use this technique for rental uint bathrooms, or if they are planning to sell their place. It's much less expensive than a full tub replacement, but again, the paint only lasts a few years. Once applied, I believe you have to use liquid cleaners only - nothing abrasive.

Answer 2

It is a highly toxic paint, very similar to that used on vehicles, but more in line with what is known as 'porcelin'. The tub needs to be prepped with sanding and all knicks filled in to an even finish. The paint is applied by high-pressure spray gun and takes four layers, each needing to be completely dry before applying the next. This takes about 6 hours to complete, and I suggest you hire a professional, they usually go by the name of Tub Doctor.

In Vancouver, BC the professional cost is approximately $350. and a new tub is $299.

Answer 3

The Glaze is a baked on powdered enamel. In less you can heat the tub to 1700 degrees it won't look the same.

Answer 4

bypass new. even as resurfacing is "sturdy sufficient" for some, it can't take any abuse. The end isn't baked on so that you want to be very careful even as utilising and cleansing. I trust questioning over the color of the bathtub. Moods and kinds change by the years and replacing out a bath isn't the finest or most inexpensive ingredient to do.