I have been hearing a clicking noise when I turn the wheel. It doesnt always happen while I am driving.. But if I put the car in park with the car running and turn the wheel back and forth.. I can definately hear the noise. I have had the struts replaced, brakes replaced.. I have been told that it could be the rack and pinion or tie tods. How much do tie rods usually cost? Has anyone dealt with the same problem? They have also lubricated some parts to see if that would help. Nothing has seemed to work. I have been given the run around. So if anyone has an idea of what this could be and how much it would cost to repair it I would greatly appreciate it.. Thanks!!
2006-09-07 14:10:35 · 8 answers · asked by K.M. 1 in Cars & Transportation ➔ Maintenance & Repairs
What your probably hearing is the front subframe flexing. This frame is constructed of aluminum and it is normal for it to flex somewhat. It's not a safety issue, just an annoyance. Some of the known areas that cause the noise are the steering gear mounting brackets and the rear body mount brackets were they are welded to the frame.
The repair is actually quite simple and involves injecting a penetrating threadlocking compound on to the welds and the surrounding areas of the previous mentioned brackets. If you go to a Chevy dealer and ask them about it, they should know what to do. Since your vehicle is a 2003 model year, I would pursue the issue as a warranty repair regardless of mileage...it's a common complaint and almost all of those vehicles exhibit that condition... . If necessary, contact the area zone rep for that dealer if they refuse to cover it under warranty.
If you are the original owner...you stand a better chance on getting it covered under warranty. If your not...remember this "the squeaky wheel gets the oil" ;)
2006-09-07 14:51:05 · answer #1 · answered by Imerc 3 · 0⤊ 0⤋
Sounds like either a steering component has gone bad or (even though it is too early) the CV joints have called it quits.
Was the car a taxi or a police car in its past life? If so, the wear and tear have taken a toll.
2006-09-07 21:13:22 · answer #2 · answered by Anonymous · 0⤊ 0⤋
Check into the CV joints. I've worn tie rods to the edge of existance and they never made any noise for me. I'd place my bet on CV joints. Check the boots on the drive shafts and look very closely for tears.
2006-09-07 21:23:39 · answer #3 · answered by Steve-o 3 · 0⤊ 0⤋
It sounds like your engine cradle(front sub frame) is loose, or the bushings are worn out, it is a real common problem. also check the rack and pinion mounts, or upper strut mount, sometimes the bearing plate goes bad, and they will click when you turn
2006-09-07 21:20:03 · answer #4 · answered by evanswolff@sbcglobal.net 1 · 0⤊ 0⤋
Your brake calipers maybe loose or a bad wheel bearing.
2006-09-07 21:32:41 · answer #5 · answered by Vulcan 1 5 · 0⤊ 0⤋
This is going to sound silly, but make sure your wheel covers on tight.
2006-09-07 21:46:48 · answer #6 · answered by Ironball 7 · 0⤊ 0⤋
Try asking the mechanics at askautopro.com. They seem to know everything!
2006-09-07 21:13:22 · answer #7 · answered by Bargain Girl of Yore 2 · 0⤊ 0⤋
possible axle
2006-09-07 22:19:38 · answer #8 · answered by racingirlsmokesem 2 · 0⤊ 0⤋