size wrench for 7/16 bolt
2006-09-06 23:13:41 · 9 answers · asked by rusti04413 1 in Cars & Transportation ➔ Maintenance & Repairs
try a 1" or 1 3/4", i think would be your best bet.
2006-09-06 23:34:50 · answer #1 · answered by -^-Smooth C-^- 4 · 0⤊ 0⤋
Hi Yes you can measure the socket required bolt heads are measured across the flats that is a bolt head is hexagonal just measure from one flat side across the bolt to the other flat side the bolt holding the blade on my mower is about 32mm across the flats and allthough i have large collection of spanners this one is a bit big i allways use a monkey wrench or large adjustable spanner these are much cheaper than a socket ,just make sure it is nice and tight on the bolt then a gentle tap with a hammer and it should come undone ok take a picture on your phone before dismatling the blade just in case as sometimes its not obvious which way up things are , i take my blade off once a year to sharpen it , best of luck regards ward
2016-03-27 01:16:47 · answer #2 · answered by ? 4 · 0⤊ 0⤋
You are talking about the diameter of the bolt right? If this is the case I do believe that KATS is correct with it being an 11/16 to fit the head of the bolt.
2006-09-07 01:15:51 · answer #3 · answered by ezachowski 6 · 0⤊ 0⤋
11/16" wrench (nut) = 7/16" bolt
2006-09-06 23:21:20 · answer #4 · answered by k@tsY 2 · 0⤊ 0⤋
Most likely 5/8 or 11/16.
2006-09-06 23:28:13 · answer #5 · answered by cybrog 4 · 0⤊ 0⤋
1/2 or 9/16
2006-09-06 23:16:53 · answer #6 · answered by k dog 4 · 1⤊ 0⤋
Use the size that fits...... duh
You can not use a metric wrench on a SAE nut/bolt or the oppisite. Close doesn't quite make it.
2006-09-06 23:22:51 · answer #7 · answered by pappy 6 · 0⤊ 0⤋
i just get the whole pack and see which one fits the best. i never could determine the correct size that i need very well
2006-09-10 15:50:21 · answer #8 · answered by Billy T 6 · 0⤊ 0⤋
u just answered your own question. My apologies didnt read the question properly.
2006-09-06 23:15:53 · answer #9 · answered by ? 3 · 0⤊ 0⤋