Do i really need to use ANTI-STATIC cable when changing pc component?

Question

ive change pc components years before plenty of time and never had a problem...

Answer 1

I always make sure to touch the metal PC case or something metal before touching a component. This helps to discharge any static in your hands/fingers. Also holding the component by the edges helps greatly. There is no real need for anti-static wrist bands. However, if your components are very expensive or you dont want to take any chances then anti-static wrist abnds are the way forward. I have bui;lt several PCs successfully without the use of anti-static wrist bands.

Answer 2

The answer is NO it is not required if you take anti-static precautions. The fine circuits and memory can be destroyed by static discharge...rubbing you feet on the carpet, wearing a polyester shirt all builds up the static on your body.

You can discharge it by touching the metal frame on your computer, assuming it is plugged in and switch off (it is then earthed). Modern electronics are more sturdy and less likely to be damaged compared with the orignal components ten years ago.

But if you regularly change components then you might as well buy one to be on the safe side.

Answer 3

I simply leave the power plugged in although switched off at the mains and touch the metal case before changing things in the case
takes care of the static and never had a problem

Answer 4

although it IS recommended it is not vital, just make sure that you take care when changing components by taking basic precautions against static discharge. If component came in anti-static bag it is a good idea to try to keep item in or surrounded by the bag until you have installed it as this offers extra protection

Answer 5

not really although recommended if you turn your computer off in the mains and keep it plugged it providing the case is metal it will be earthed otherwise make sure you keep in contact with something like a radiator. anti static risk bands are very cheap and often come standard in 16/32 pieces toolkits and above.

Answer 6

I never have either. Since the computer case is made of metal, provided you touch it before you touch any component there really shouldn't be a problem.

Answer 7

I ruined a card several years ago from static discharge, but I didn't particularly learn a lesson from that experience. The risk increases in the winter when it's dry and cold and probably during solar flares and lightning storms.

Answer 8

Ive never bothered using one.... But just to take precaution touch a radiator or something earthed in your house before potching with your pc.

Even if thats touching your pc's case before you unplug from the mains supply (as this is earthed).

Answer 9

Keep the power supply connected but switched off and keep touching the metal chassis and you should have no problems with static.

I've been a PC engineer for 17 years and I've never had a problem.

Answer 10

whilst the submit encounters an blunders, it ussally responds with a beep sequence. placed interest to this sort of beep and then study it to the subsequent: secure, short beeps = ability grant could be undesirable long non-end beep tone = memory failure secure, long beeps = ability grant undesirable No beep = ability grant undesirable, gadget no longer plugged in, or ability no longer became on No beep = If each thing seems to be functioning properly there could be a concern with the 'beeper' itself. The gadget will many times beep one short beep. One long, 2 short beeps= Video card failure those codes are actually not fail secure, there could be different subject concerns in touch. For what you defined seems such as you basically builded a clean gadget, all greater moderen mobos with the recent processors require minimum 350w grant in spite of what they say. make specific your PSU meets this minimum. in any different case replace the board evaluate some thing like MSI, they are notably sturdy. sturdy luck.