English Deutsch Français Italiano Español Português 繁體中文 Bahasa Indonesia Tiếng Việt ภาษาไทย
All categories

2006-09-02 11:42:47 · 6 answers · asked by cathmommy2001 1 in Games & Recreation Hobbies & Crafts

I keep pulling more stitches out, twisting the stitches different ways, etc. I just got so mad, I pulled the whole thing out!!!

2006-09-02 11:44:16 · update #1

6 answers

Here is an actual video detailing how to pick up a stitch, the visual is way better than a written description :)

2006-09-02 14:14:38 · answer #1 · answered by Behhar B 4 · 0 0

in basic terms take your knitting needle an slip it into the final loop popping out of the place the sew became into dropped. in case you leaf by that loop you will see a right this moment piece of yarn coming from the superb to the left and not related to something. positioned your needle decrease than that and pull it by and you have picked up the backside sew. Now if there are extra rows do the comparable to them yet once you have gotten to extra that 4 or 5 rows that have the dropped sew - - - Pull your artwork down some rows above the dropped sew. in case you do it this way you may have the stitches conform yet once you do extra desirable than the 4 or 5 rows it is going to pull the yarn and you will somewhat see the version interior the dimensions of the stitches. i'm not sure what you recommend with the help of the little knotted looking sew on the tip of the development. Is there in basic terms one and the place is it located.?

2016-12-18 03:49:24 · answer #2 · answered by Anonymous · 0 0

Before you start ripping out your knitting, take a smaller sized knitting needle--preferably a circular knitting needle--and pick up the stitches a row or two below the dropped stitch. Pick up all of the stitches in the row, then start ripping out your knitting. When you get close to the circular needle, go slowly and check to make sure the stitches that you picked up are all in the same row. If not, fix it before you rip out any more.

When you finally rip back and reach the circular needle, all of your stitches on the row will be on that needle. You can knit off of that needle onto your working needle and continue knitting from there.

2006-09-03 06:32:53 · answer #3 · answered by bogiebogie 5 · 0 0

I think the easiest way to do it is to think of it as a grid. Find the dropped stitch, and then look at the row you're on. If there's a pattern involved, try to figure out how many rows back you were so that you can figure out which stitch that should have been.

If it's too complicated, you might as well just pull it up as if it was all stockinette pattern rather than pull it all out and start over. That way, at some point later, you can always trace that stitch back, pull it out and do it over when you finally understand where in the pattern you were at.

Good luck!

2006-09-03 08:23:09 · answer #4 · answered by sandra_panda 6 · 0 0

As long as the stitch is not to far down you can pick up a stitch using a crochet needle. Find the loop and weave it all the way up to the row you are working on. Than you will not have to take it al apart.

2006-09-02 12:31:48 · answer #5 · answered by lilly2 2 · 0 0

You have to pick up the stitches with the needle, one by one, it doesn't matter if some of them are twisted, all you have to do is look at every single one before knitting it again and turn it if it is twisted.

2006-09-02 14:41:34 · answer #6 · answered by Atanasia 2 · 0 0

fedest.com, questions and answers