2006-08-31 13:29:02 · 7 answers · asked by cam10957 1 in Home & Garden ➔ Maintenance & Repairs
Have you tried going to the DIY Network website? (Do It Yourself)
I think their address is diynet.com....but you should be able to locate it with an internet search.
I hear they have detailed information on how to do EVERYTHING. Hope this helps...
2006-08-31 13:31:58 · answer #1 · answered by CassandraM 6 · 0⤊ 0⤋
First, shut off the circuit breaker for the water heater. Attach a garden hose to the drain at the bottom. Open the drain then open the relief valve at the top of the unit. After the water has drained out, and there will be some left in the bottom, disconnect the water lines at the top. There should be a shut off valve for the incoming line at the top. Be sure to turn it off before disconnecting the water lines and draining the unit. With the new heater be sure to buy an installation kit. It should include copper flex lines (connect to existing incoming and outgoing lines. There also should be two threaded nipples with the kit. They go into the ports on the top of the heater. Remove the two plastic inserts in the top of the heater before attaching the new lines. Remember the water coming out is hot. It may be a good idea to turn off the heater the day before you change it. There should be ample hot water to see you through.
2006-08-31 20:40:06 · answer #2 · answered by Paleo C 3 · 1⤊ 0⤋
The best way is to replace it with an identical unit you are taking out. If it is a gas water heater the hard part will be getting the flue right. The sheet metal exhaust flue has to be right to get all the fumes out. That's why I always install the same type I'm taking out. I know the sheet metal will fit up right. Also, if you have to cut any of the piping, when you reinstall it, put in unions, it will make it easyer in the future.
2006-09-04 10:47:21 · answer #3 · answered by c321arty 3 · 0⤊ 0⤋
Paleo C has a very good description to remove an Electric Water Heater. But remember to fill with water COMPLETELY before turning on the circuit breaker, If not you will have to replace top element as with no water around it will only last a few seconds before it melts...leave one of the hot water faucets open and when you get a good flow of water out of it you can then turn on breaker...
2006-08-31 22:01:28 · answer #4 · answered by RoeB 5 · 0⤊ 0⤋
Go to your local Lowes or Home Depot. They have handouts on this project. They are esy to follow and tell you the tools and materials you need. They are step by step instructions. Good luck.
2006-08-31 20:35:10 · answer #5 · answered by Anonymous · 1⤊ 0⤋
save water u may need durring . shut off water . shut off gas . disconnect lines where needed and can be reconnected on the new one . vent pipe will have to be removed . out with the old in with the new . replace check for leaks .light . you can have your gas company check if not sure. careful and good luck.
2006-08-31 20:36:01 · answer #6 · answered by martinmm 7 · 0⤊ 0⤋
If it is gas fired, get a plumber. If installed improperly, it can be fatal.
2006-08-31 20:34:47 · answer #7 · answered by Anonymous · 0⤊ 0⤋