It seems to be bhind that. There is some kind of plug with a hold-doen bolt.
2006-08-29 14:15:56 · 7 answers · asked by Mike K 1 in Cars & Transportation ➔ Maintenance & Repairs
Can you take a picture of it, and send to mikajohnpitts@yahoo.com, I can try my best to help you out, If I can see what you mean.
2006-08-29 14:20:10 · answer #1 · answered by Silverstang 7 · 1⤊ 0⤋
What engine is it? If it is a 3.1 and the plug is about 1 1/2 inches in dia. and leaking oil. It is the oil pump drive gear housing. If it is a 3.1 engine and you see antifreeze in that area, you probably have a leaking intake gasket. Check your oil, if it looks milky, you have a bad coolant leak, and it is getting into the oil. Any intake leaks in that area, will eventually get into the oil.
2006-08-29 14:28:43 · answer #2 · answered by B H 3 · 1⤊ 0⤋
That would be the left of the intake manifold the hole was where on earlier cars distributor was located That cover is O ringed or gasketed try un bolting and wiggeling it up and out reseal reinstall
2006-08-29 14:23:58 · answer #3 · answered by John Paul 7 · 0⤊ 0⤋
Is it one of the after market freeze plugs ? Is it on the front of one of the heads ? It sounds like one of those rubber freeze plugs with the bolted center to tighten it. I can't be sure without seeing it though..........so I couldn't say for sure.
2006-08-29 17:43:13 · answer #4 · answered by turbietech 4 · 0⤊ 0⤋
If you can figure out what is leaking that might make it easier. If it is antifreeze, you may need a new thermostat, or one of the hose clamps could be leaking.
2006-08-29 14:20:28 · answer #5 · answered by please remove me from here 4 · 0⤊ 2⤋
could be the intake manifold take it to a shop and have them pressure test it
2006-08-29 16:50:50 · answer #6 · answered by rwings8215 5 · 0⤊ 0⤋
if is oil is the oil pump drive plug and it need a oil pump drive (o) ring
2006-08-29 14:26:44 · answer #7 · answered by murraymaidan 2 · 0⤊ 0⤋