English Deutsch Français Italiano Español Português 繁體中文 Bahasa Indonesia Tiếng Việt ภาษาไทย
All categories

Is the screen wash motor located with the water bottle and easy to remove/replace? The car is a peugeot 106 (1999). Water bottle is full, no fuses appear to be blown.

2006-08-29 09:54:34 · 5 answers · asked by Anonymous in Cars & Transportation Car Makes Peugeot

5 answers

It's the motor found at the bottom of the screen wash bottle, I had this on a 306, bought the motor for a fiver took about ten minutes to fit as was a bit awkward to get to, just a plug part.

Go to a scrappy and you'll see what it looks like and where it fits too.

good luck!

2006-08-29 10:33:20 · answer #1 · answered by Dale H 2 · 0 0

Genuine Peugeot Parts washer motor is about £7-£8 very easy to fit about 5 mins work..Tip, buy a new rubber seal at the same time about £1 for a genuine Pug one..fit at the same time

2006-08-29 11:45:42 · answer #2 · answered by Lone Wolf 2 · 0 0

you need to check the power and earth to the washer bottle motor which is located in the o/s/f wheel arch guard in front of wheel. If you have these and no fuses are blown then you will require a new washer pump motor.

2006-08-29 10:31:25 · answer #3 · answered by michael c 1 · 0 0

Sounds like the motor has burnt out.

2006-08-29 10:03:00 · answer #4 · answered by mary.cargill55@btinternet.com 2 · 0 0

mine did this alot too - normally 4 times a year.

it was the fuse each time though. are you sure you have checked them all. check your hand book before going any further.

2006-08-29 10:08:07 · answer #5 · answered by 'Dr Greene' 7 · 0 0

fedest.com, questions and answers