Is it easyer to just pull the hole motor and trans axle on a 92 accord 4 cyl. to change the cluch? seems like the hole front end has to come off to get the trans axel out from underneth
2006-08-29 05:47:15 · 3 answers · asked by Anonymous in Cars & Transportation ➔ Maintenance & Repairs
if you dont have a manual check this out. its about 15 bucks and it gives step by step instructions with pictures. good luck.
2006-08-29 06:19:55 · answer #1 · answered by -^-Smooth C-^- 4 · 0⤊ 0⤋
It is easier to jack the car up and remove the axle and strut than removing the entire engine. There are too many connections to the engine including vacuum lines, electrical fuel and water. Just do it the way the repair manual describes it. You have a lot less chance of doing damage to some component or reconnecting things incorrectly.
2006-08-29 12:58:14 · answer #2 · answered by yes_its_me 7 · 0⤊ 0⤋
no u can drop the trani after u take the motor braket bolts out the the trani should be hangin down and this is all after u take the drive axel out then change the clutch and dont forget to change the barrin in the trani but trust it is going to be a ***** to get out but good luck dawg
2006-08-29 12:55:40 · answer #3 · answered by chris 2 · 0⤊ 0⤋