the make is Bosch exxcel , maxxi. Model SG343502gb/35. Have gone the route of cleaning and checking that the spray blade is not obsructed, when flicked by hand it turns freely,how can I check further down in machine for any blockage
2006-08-29 02:56:57 · 4 answers · asked by Anonymous in Home & Garden ➔ Maintenance & Repairs
Wow. I have the SAME dishawasher and HAD the same problem.I found out that there is a prescreen filter,where the supply hose,screws in.It is in the front (behind the kick panel).Turn off the water source and unscrew this hose.Pull it out and you will see a little orange/blue screen.It was totally clogged with sediment.I ended up just removing the thing and has worked fine since.I have had the dishwasher for over 2 years now.Did you install it? There are tricky units.They have a channel underneath the unit that the lines have to go throug.Make sure you do not have a pinched line.Use stainless steel supply lines too!
2006-08-29 03:17:51 · answer #1 · answered by Anonymous · 0⤊ 0⤋
Make sure that the spray bar holes are not clogged with foreign matter.
It`s the holes in the spray bar that the water jets out of to spin the bar.
2006-09-01 05:49:43 · answer #2 · answered by Spanner 6 · 0⤊ 0⤋
sounds like the timer for the cycle may be shot. You can look in owners manual for part and location of
2006-08-29 03:03:03 · answer #3 · answered by thomcat 1 · 0⤊ 0⤋
Start with water pump(it is in the bottom)make sure your bottom(drains) is clean(the pump recirculates the water)
2006-08-29 03:03:50 · answer #4 · answered by paulofhouston 6 · 0⤊ 0⤋