English Deutsch Français Italiano Español Português 繁體中文 Bahasa Indonesia Tiếng Việt ภาษาไทย
All categories

9 answers

pour dawn dish soap on spill let set for about three hours
while waiting sit in chair close to to oil spot and have favorite beer should drink about 6.
them add small amount of water and scrub in circular motion until spot is gone may take extra six packs if you want to get the driveway looking good. remember the secret iis cold six packs

2006-08-28 04:56:18 · answer #1 · answered by matzaballboy 4 · 0 0

Removing the fresh stain from the driveway will require a regular scrub brush, some liquid dish soap and water. All you need to do is squirt some liquid dish soap onto the stain and add some water. Be sure to wet down the surrounding concrete as well. This will prevent oil released during the cleaning process from causing a secondary stain. Scrub the stain vigorously and add enough water to make a rich lather of soap.

The soap will emulsify the oil and lift it out of the concrete. If you simply rinse the driveway the oil will pollute your yard or street.

2006-08-28 04:53:40 · answer #2 · answered by cookiesmom 7 · 0 0

For a cement driveway, I can tell you that it is VERY difficult to remove oil stains. But several of the answers listed above seem promising. But be prepared to repeat several times! The least effective way is cat litter; don't waste your time with that. There is no easy way. And buy a new, stiff old-fashioned scrub brush, and you will need one. Good luck, you'll need it.

2006-08-28 07:11:19 · answer #3 · answered by MrZ 6 · 0 0

1. Pour cola on the oily or dry stained areas, and leave the cola on overnight. Squirt a generous amount of dishwashing liquid into a bucket until you have a good lather. Rinse with the soapy water, then with a garden hose.

2. Sprinkle baking soda or an absorbent powder such as cornmeal or sawdust on the oily spots. If the stain is dry, wet it first to make a scouring paste. Scrub with a stiff brush or push broom.

3. Sprinkle automatic dishwasher detergent on the oily concrete. Leave it for several minutes, then pour boiling water on the stained area. Scrub with a stiff brush or push broom, then rinse.

4. Try a commercial concrete cleaner such as Garage and Driveway Cleaner by Red Devil Co. or a grease solvent such as Benzine. Follow the manufacturer's instructions.

5. Sprinkle trisodium phosphate (TSP) on the oily concrete. If the stain is dry, wet it first. Let it stand for 30 minutes. Scrub using a stiff broom. TSP is a dangerous product; if you must use it, wear rubber or latex gloves, safety goggles and protective clothing. Also, never wash a TSP product down storm drains.

6. As a last resort, combat tough spills with muriatic acid and a pressure washer. Apply the acid following the manufacturer's directions, and let it soak for several seconds. Follow with a pressure washer set at 2,500 to 3,000 lbs. per square inch (psi), or 176 to 211 kg per square cm. Like TSP, muriatic acid is a dangerous product; likewise, if you must use it, wear rubber or latex gloves, safety goggles and protective clothing, and never wash such a product down storm drains.

7. After trying any of the strategies above, sprinkle baking soda over the cleaned area to neutralize the solution you've used.

2006-08-28 04:51:19 · answer #4 · answered by rr 6 · 0 0

Auto shops sell Driveway Cleaner for under $10. All you need is that and a scrub brush. I got some recently from an AutoZone store.

2006-08-28 04:50:57 · answer #5 · answered by prinsin99 3 · 0 0

If you use Kitty litter be sure to use regular clay. The fresh step and scented won't work.

2006-08-28 04:53:55 · answer #6 · answered by innerchambermusic 2 · 0 0

1st spray with wd-40 let it sit for minute and wash away with your hose.

2006-08-28 04:49:38 · answer #7 · answered by Bears#1 2 · 0 1

kitty litter

2006-08-28 04:48:29 · answer #8 · answered by JULIE 7 · 0 0

Gunk you can buy it in the uk

2006-08-28 08:16:35 · answer #9 · answered by Petrol Head 2 · 0 0

fedest.com, questions and answers