What is the most effective way to build a tobacco bong?

Question

"tobacco"....

Answer 1

By rolling the tobacco.

Answer 2

lol Right, "tobacco." If it's tobacco, the piece iss referred to as a "waterpipe." It's only called a "bong" when it's being used to smoke marijuana. ; ) lol I learned this at a head shop- they can refuse to sell to you if you go in and ask for a "bong."

Anyway, if you're not a glassblower, the best thing to do is find something glass. My friend used a Jack Daniel's bottle and drilled a hole into it for the female.

Just find a glass bottle you like that has a top good for a mouthpiece, drill a hole near the base for the female, stick a female piece in with a rubber piece around it to keep it in place. Then all you need is a slide, some weed... I mean, tobacco... and a lighter.

Answer 3

i know the cheapest way, lol. all you need is tin-foil and a pop bottle and a lighter and something to poke into the hot plastic. Drink the pop, take the lighter and heat up a small spot less than half way from the bottom, poke the hot plastic with a round object to make a hole (a pen or pencil would work), roll a piece of tin-foil up using the same round object to poke the hole in the bottle, then at the end of the tinfoil roll bend it up a little (crimp it) so the tobacco doesn't fall down the tube and into the water. fill the bottle with some water and you're ready to go. damn i hope i don't get reported for answering this....NOTE: this is for tobacco purposes only. DON'T DO DRUGZ!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!

Answer 4

Gimme a break. tobacco bong? LOL. go to one of these sites below... and instead of using weed use it for tobacco. LOL you crack me up.

Answer 5

Tobacco bong ????? Who do you think you're kidding ? LOL !
( Yeah, that was REAL indiscreet! )

Answer 6

Tobacco? you are joking, right?

Answer 7

try rolling it