fence post where the gate is attached is spliting at the top. How can I repair it without replacing the post?

Answer 1

I imagine you are refering to a wooden post....Larger hardware stores sell all sizes of clamps which one can improvise to hold the gate...try that

Answer 2

you may be able to use a combination of the previous two answers. If the split is large enough to inject wood glue into the post, you can then install a clamp to hold it in place while the glue holds.

For clamps I would recommend two alternative. You may be able to find 1/4 inch steel plates, that are the correct width, or you can use 1/4 inch oak, and cut strips to the appropriate dimensions. Tack them in place on both sides of the post, and drill holes through both supports and the post itself. Use the appropriate size threaded bolt-washer-nut assembly to pull the post together. Just be sure to use galvanized bolts, washers, and nuts, it it is exposed to the elements.

Now....don't get your hopes up. Eventually, all wooden posts have to be replaced.

Answer 3

Well, you can try drilling it and putting a carrage bolt through it, with washers at both ends. You can try wrapping it with metal strap. You can try screws through one side into the other side. I would think the best bet is one of the first two suggestions, then you should do something to seal the top and the crack on the sides to keep water ot of it.

Answer 4

Greets....
All the above ----plus.......
Try looking at Simpson Strong-tie products at local building store...
These are galvanized metal - and the one you want can be used to cap the post... it is usually used at the bottom in a post-to-floor arrangement, but I see no reason why it cannot be stuck on the other end.
Looks kinda like a square cup.-- sorta.

luck

Answer 5

I'd put some wood glue in it, then bind tightly with a strap or clamp until dry. A permanent strap may be necessary though. The kind you ratchet tighter. ($14.95 for 3 at HD)

Answer 6

cutting the top at 45 angle for runoff