2006-08-23 10:51:50 · 2 answers · asked by Anonymous in Cars & Transportation ➔ Maintenance & Repairs
I have a Boulevard C90, so it should be the same. Unfortunatly my bike & probably yours , doesn't have a center stand so you will have to get a low profile catch basin to get under the bike.. The drain plug is located on the bottom of the bike near the back of the crankcase. 13 mm wrench should be the right size. Take the plug out and allow all the oil to drain out & then reinstall the plug. Then you will have to move your basin to the front of the motor, this is where the oil filter is. It's a spin on type like a car. Make sure you wipe the o-ring on the new filter with some oil. Put the new filter on as tight as your can by hand. On my Boulevard, I have to remove the rear chrome cover on the right side of the bike to get access to the fill plug. Put in about 3 litres of recommended oil and check the level. This might require 2 people of yours uses a sight glass for level. Make sure the bike it straight up when checking level. Once it's full, start the bike so the oil filter can charge and then shut it down again. let it sit for a few minutes and then check & fill as need to get to the full mark and your all done !!! Good Luck.
2006-08-23 11:54:16 · answer #1 · answered by trannyman166 3 · 4⤊ 0⤋
trun it upside down and throw a match on it
2006-08-23 11:51:14 · answer #2 · answered by mike L 4 · 0⤊ 3⤋