The engine is a 2.8 Liter V6 with a 5 speed stick shift on the floor.
2006-08-22 10:10:34 · 6 answers · asked by Edward J 3 in Cars & Transportation ➔ Maintenance & Repairs
its actually not a hard vehicle to do. but the flywheel needs to be surfaced, you need to replace, the pressure plate,throw out bearing and the pilot bushing. also would be a good time to change the trans fluid as well as check the u joints and any seals replaced. also you would want to check the rear main seal on the engine and remember to torque the flywheeel correctly as you could damage the crankshaft flange and then the rear main would be leaking. you have to be able to get the vehicle high enough to work underneath it. if you dont have the proper tools i wouldnt suggest it
2006-08-22 10:44:14 · answer #1 · answered by Christian 7 · 1⤊ 0⤋
It relies upon on who replaced it for you. maximum shop hard artwork fee selection from $fifty 5 to $80 5 funds in step with hour. to empty the cooling gadget, replace the hose and fill up and verify out the gadget... sure, $40 funds may be common.
2016-12-14 10:00:31 · answer #2 · answered by Anonymous · 0⤊ 0⤋
Buy a repair manual for your vehicle. Much easier than explaining it step by step...whew. Good luck.
2006-08-22 13:37:16 · answer #3 · answered by Anonymous · 0⤊ 1⤋
just like do it to a 350 v8
2006-08-22 11:21:00 · answer #4 · answered by Anonymous · 0⤊ 1⤋
take old clutch out and stick in new cluch... if you can't do that then don't **** with it!!!
2006-08-22 10:13:42 · answer #5 · answered by Anonymous · 0⤊ 4⤋
you need a screwdriver
2006-08-22 10:12:12 · answer #6 · answered by Anonymous · 0⤊ 3⤋