2006-08-20 07:30:24 · 6 answers · asked by Jag 1 in Cars & Transportation ➔ Maintenance & Repairs
start you car then un hook your posative battery cable if your engine cuts out its your altinator if its still running pick up a new battery
2006-08-20 08:49:56 · answer #1 · answered by BICCA 3 · 0⤊ 0⤋
I even have seen this one earlier it drops communication while it stalls out! while you have a undesirable PCM and you may desire to verify the improve solenoid for the right resistance or you will blow the alternative PCM from a shorted improve solenoid and which will injury the drivers interior the PCM! (do no longer bounce ANY PINS on the strategies link CONNECTOR) As this serves no valid objective on a OBDII motor vehicle and not something will blink, all you have in that link are 2 type II records strains,sensor floor and 12 volt+
2016-12-11 12:03:44 · answer #2 · answered by ? 4 · 0⤊ 0⤋
Have a competent car electrician take a hard look at the alternator and the battery terminals.
2006-08-20 07:50:20 · answer #3 · answered by Bummerang 5 · 0⤊ 0⤋
Also could be a bad alternator, not charging the battery. Take it to a place like Autozone, and have them tested. They'd be able to tell you which is bad. Good luck.
2006-08-20 07:35:44 · answer #4 · answered by Silverstang 7 · 0⤊ 0⤋
no have the alternator checked, along with the battery, and make sure all of the electrical systems are turing off when you leave the car
2006-08-20 07:35:46 · answer #5 · answered by dave45717 1 · 0⤊ 0⤋
could be just battery - I would take it to your friendly parts store - they frequently will check your battery and charging system free - you might find your problem that way and it will be free until you need to buy parts
2006-08-20 07:36:22 · answer #6 · answered by oregontimmy41 3 · 0⤊ 0⤋