2006-08-18 02:24:40 · 3 answers · asked by Eric B 1 in Cars & Transportation ➔ Maintenance & Repairs
2.5 mm drilled hole.
2006-08-18 02:29:04 · answer #1 · answered by Pirate of the Bassein Creek 4 · 0⤊ 0⤋
3/16 approx. The 4 is hardness, 8 being very hard. With a four you should be able to self-tap through 1/8" mild iron. With an 8 up to half inch of iron.
2006-08-18 09:36:48 · answer #2 · answered by Thomas S 6 · 0⤊ 0⤋
no sure off hand but for future use if U have a drill hold, one or the one that has holes cut in it for each specific drill bit, or a drill bit guide.
Use that to put the screw into, if with wriggling the screw around, not turning it, U can push the screw into the hole, then go for the next one down, if it even jumps one turn use the smaller one, that's what i do.
i hope this helps for the future
2006-08-18 09:36:24 · answer #3 · answered by davethestickman 2 · 0⤊ 0⤋