2006-08-13 14:43:58 · 19 answers · asked by onya50 1 in Home & Garden ➔ Maintenance & Repairs
Gosh ...thanks alot. And here's a bit of trivia for you.
Greek rainmakers dipped oak branches in water when praying for rain, and sometimes it rained thereafter. The Romans threw clay images into the Tiber River, and that, too, was oftentimes followed by rain. Teutonic rainmakers poured water over nude girls. That never did produce rain, but they clung to the ritual.
2006-08-13 15:04:19 · answer #1 · answered by Sam 7 · 0⤊ 1⤋
Kristy had the right idea
since pressure is greater on the cold side than the hot side the only way to fix this is to install a set of pressure balanced taps
would take a good plumber less than 3 hours depending on the access required. Spend the money on the faucet and buy a named brand like Delta or Moen they last alot longer than the generic brands and parts are easier to get
2006-08-14 00:32:05 · answer #2 · answered by Anonymous · 1⤊ 0⤋
that' just comes from having a small water heater. It happens in a lot of homes though, I have the same problem. The thing to do would be get a bigger and more efficient heater installed, but that costs a lot of money. IF you don't have the money to be replacing the water heater than just make sure everyone in your house knows not to turn on the shower when you're in there.
2006-08-13 21:50:45 · answer #3 · answered by damainavent 2 · 0⤊ 1⤋
Ours used to..When we bought new faucets they said that they would not cause the shower water to change temp when another faucet was on or the toilet was flushed..It worked..We don't have to worry about freezing now.
2006-08-13 21:50:40 · answer #4 · answered by kristy2163 3 · 0⤊ 0⤋
Used to have the same problem. When I had some work done in my bathroom, the plumber ran separate lines for the h&c water in the bath. Now no more problem.
So, unless you can get the plumbing changed....you have to take a shower when no one else is using the water.
2006-08-13 21:51:05 · answer #5 · answered by Stephen B 3 · 0⤊ 0⤋
Don't use faucets while showering, or make sure that you use all of your faucety stufffs before you shower. Either that or get used to cold showers! Just kidding...Good Luck!
2006-08-13 21:50:02 · answer #6 · answered by Paige 3 · 0⤊ 1⤋
Pressure may be too low....
If its just one faucet, maybe you can install a priority valve that minimizes hot water loss when you're taking a shower.
2006-08-13 21:47:35 · answer #7 · answered by SpeedyTV.com 2 · 0⤊ 1⤋
Low water pressure in your lines. How old is your water heater? It may need to be cleaned out as calcium tends to build up over time. Your supply lines may be restricted as well.
2006-08-13 21:48:13 · answer #8 · answered by Anonymous · 0⤊ 1⤋
You don't have a big enough hot water heater to support both uses of hot water. Try installing a bigger heater.
Thanks!
2006-08-13 21:47:32 · answer #9 · answered by rita_alabama 6 · 0⤊ 1⤋
All your pipes must be connected. Most older houses are like that
My house doesn't b/c they all run on separate lines.
2006-08-13 21:47:32 · answer #10 · answered by Anonymous · 0⤊ 0⤋