2006-08-13 04:47:43 · 10 answers · asked by Tim 1 in Cars & Transportation ➔ Maintenance & Repairs
If you have removed *all* of the bolts, the gasket is probably holding it in place. You can pry it off with a screw driver.
2006-08-13 04:51:50 · answer #1 · answered by ceprn 6 · 0⤊ 0⤋
Whats holding it is most likely the gasket, as some are sealed with rtv and such. Try to pry it apart, and also make sure there isn't a bolt hiding under a pulley. Hope that helps.
2006-08-13 04:51:15 · answer #2 · answered by Silverstang 7 · 0⤊ 0⤋
in case you might have adequate money it, get videocams and stick them interior the trees or some thing surrounding your place and barn in case you have one. you opt for for surveillance. Or hire somebody to visual show unit the area on stay cam. in case you cant have adequate money any of that, then i assume you have accomplished all you are able to at this element. i'd possibly deliver a record to the FBI too, because hate crimes have been committed against you interior the previous. And previous that, it can be quite demanding to stay in a community like that, possibly you are able to evaluate shifting if in any respect possible.
2016-11-04 12:02:37 · answer #3 · answered by shea 4 · 0⤊ 0⤋
double check for more bolts there could be one left that is hi dding it should come off thee shouldn't be anything but may be Little gasket cement holding it .try and pry with a lite bar so the bar bends and dint break your core or if room smack it with a dead blow hammer. good luck and be careful
2006-08-13 05:00:02 · answer #4 · answered by ihclyde 2 · 0⤊ 0⤋
when a water pump is installed they usually put some silicone on it and that will hold it some so you will have to use a little force by hand
2006-08-13 04:53:17 · answer #5 · answered by Vicki W 1 · 0⤊ 0⤋
use a flat head screw driver and pry it off gently if it seems still tight you missed a bolt somewhere
2006-08-13 05:00:03 · answer #6 · answered by BICCA 3 · 0⤊ 0⤋
Tap on the gasket (lightly!). It may be glued to the block by dried grease.
2006-08-13 04:51:31 · answer #7 · answered by nursesr4evr 7 · 0⤊ 0⤋
it's rusted, go to pep boys and get some spray, and then you have to bang it with a rubber mallot, should pop loose. bang, spray, bang spray, after about half an hour, voila! it'll be off.
2006-08-13 04:52:09 · answer #8 · answered by Jodeci 2 · 0⤊ 0⤋
Feel around with your fingers. You probably missed one that you can't see.
2006-08-13 04:54:35 · answer #9 · answered by Mr. KnowItAll 7 · 0⤊ 0⤋
look all around it, maybe u missed something.
2006-08-13 04:54:43 · answer #10 · answered by Hollisterdude 2 · 0⤊ 0⤋