how do you get rid of mold smell from under a house?

Question

no mold is visible at all.

Answer 1

If you frequently smell musty odors or feel damp spots on the floors or walls of your basement, laundry room, or storage area during warm, humid weather, you need a dehumidifier.

The recommended humidity level inside your home during the summer is around 40 to 50 percent, and very humid conditions over an extended period can leave you uncomfortable and adversely affect your home. Musty smells, peeling wallpaper, warped wood, rusting tools, blistered paint and moisture dripping from pipes are signs of excessive humidity. These conditions are most common during spring and summer.

Dehumidifiers remove excess humidity by drawing moist room air over cold refrigerated coils. The moisture in the air condenses into droplets as it passes over the cold surfaces in the dehumidifier and into a container. "Dried" air then returns to the room at approximately its original temperature. For best results, the unit should be located in an area closed to outdoor air and where air movement in and out of the unit is not restricted.

Here are some features to look for on many of today's models:

Automatic turn-off switch that shuts unit off when container is full
Signal light indicating that container is full
Adjustable "fill" control that stops unit at the desired "fill" level
Automatic humidistat that maintains the desired humidity level
Automatic defrost control which shuts compressor off when freeze-up develops and turns it on again when ice is melted. (This occurs when temperature and relative humidity are low.)
Combination dehumidifier/heater to warm a room that tends to be chilly frequently
Quiet-running compressors and fans
Easy-to-reach controls
Easy-to-clean grille, condenser coil and container
Rustproof, spill-proof container with built-in handles for portability
Drain-hose fitting to let water run continuously to a convenient drain
Wheels or rollers for easy mobility
Rust-resistant cabinet.
While control or built-in features may increase a model's convenience of operation, they also raise its price. Consider each option carefully before you decide it is worth purchasing. But the most important consideration is "water removal capacity," the number of pints of water removed from the air in 24 hours.

Energy efficiency is important in dehumidifiers. Differences of only 85 watts may add 20 kWh daily to your summer electric bill. Some models let the fan run continuously to circulate air back to the humidistat. Since in most situations the moisture content will be the same throughout the enclosed area being treated, this may be an unnecessary energy expense.

Place the dehumidifier at least 6 inches from the nearest wall where air can flow freely to and from all sides. Avoid locating it in a room corner or near a large piece of furniture. Shut all doors and windows to the area to be dehumidified.

For the first few days of operation, turn the humidistat, if the model has one, to drier or "extra dry." This aids moisture removal from furnishings as well as room air. After the area has dried, adjust the humidistat to your particular comfort level.

Before you empty the water pan or bucket, turn the machine off and also disconnect the power cord. This eliminates any possibility of electric shock if you spill water and there is a fault in the grounding
system of the unit or your home wiring. Be sure the area, the unit, and you are dry before you reconnect the cord.

Dehumidifiers operate most effectively at air temperatures about 70 F. At temperatures below 65 F frost may form on the coils (which are kept cold to condense as much moisture as possible). If this happens, shut it off, and wait for it to defrost before running again. Frost cuts down air circulation so the dehumidifying process does not work, and may damage the coils. This problem usually occurs in cool basements in spring or fall; check the appliance if temperature hovers near that point.

As water condenses out of the air, heat is given off, raising the temperature slightly in the area around the appliance. This warmer air results in a lower relative humidity.

Cleaning

Dehumidifiers need little upkeep or care. The following simple procedures are sufficient:

Always unplug the power cord before cleaning the unit. For regular cleaning, dust the grilles or louvers with a soft brush or the dusting attachment of a vacuum cleaner. Either dust the cabinet or wipe it with a damp cloth. Every few weeks, scrub the inside of the water container with a sponge or soft cloth and a mild detergent to discourage the growth of mold, mildew, or bacteria. At least once each season, remove all dust and lint from the cold coils with a soft brush.

Always plug a dehumidifier into a three hole grounded outlet. If there is none where you want to put the unit, make sure you install one properly. Using extension cords is not advised because if an extension rests on a damp floor or if water spills on it, is a shock hazard. If you must use an extension cord, be sure it has a three-hole receptacle and three-prong plug for grounding. If a three-hole, grounded outlet is not available, convert it following our instructions and grounding properly. This is particularly important for a dehumidifier because it may be operated on a damp floor that could conduct electricity and because it collects water, which could spill and cause an electrical accident. Never remove the third prong from a dehumidifier plug; to do so invites an electrical accident.

A dehumidifier's fan motor should either be permanently oiled or easy to reach for oiling; the refrigeration system motor is sealed and never needs oiling.

Answer 2

Is it a crawlspace that you are talking about, or the basement?
If there is ventilation, mold should not thrive. If you've taken care of the mold problem, but the smell lingers on, you might try putting charcoal briquettes or kitty litter to absorb any lingering dampness or odor. The key is ventilation though.

Answer 3

The answers of air circulation are correct. Once that is corrected you won't have new smells and the old should not get worse, but, that won't remove the smells that are there now. I've found the most effective way is with a powerfull ozone treatment. This needs to be done by a professional remediation specialist. They use these ozone generators to remove smoke and other musty odors after floods and fires.

Answer 4

You need air movement and lots of it. An inexpensive way to achieve this is to place a high-powered box fan on either end of your foundation; one blowing in, one blowing out. Take care to protect the electrical components from water. The air movement should eventually dehydrate the excess moisture which is causing the mold growth. Good luck and God bless you.

Answer 5

if you have access to the area a mixture of water and clorox and spray the area.
use a small garden sprayer to apply.
make sure you have plenty of ventilation during the process
also the smell may be coming from poor ventilation, if this is the case you will have to put in some vents or leave some windows open if you have them

Answer 6

*There might be some type of water damage in your home and you have yet to discover where it is. Inspect your home*

Keep windows open throughout the day to ventilate your home
When you clean your home use a deodorizing/disinfectant cleanser
Spray some Oust, Febreeze, or burn fragrant some candles to give your home a pleasant aroma.

Answer 7

Bleach is the only thing I know that always kills mold.

Answer 8

Get heaters under there and get it dry. Mostly that will do it. After that ventilate.

Answer 9

hang about 100 tree shaped airfreshners....