English Deutsch Français Italiano Español Português 繁體中文 Bahasa Indonesia Tiếng Việt ภาษาไทย
All categories

The pipe is in the little closet with the furnace unit. Water is backing up. How do I remove the clog?

2006-08-11 16:02:21 · 7 answers · asked by K_Bob 1 in Home & Garden Maintenance & Repairs

7 answers

Joshua hit the nail on the head. Let me add some specifics to make your job a bit easier.

Find the end of the pvc drain line, which should be located near the outside (condensing) unit. Place the suction hose of the high-powered Shop Vac (5 h.p.) over the pipe and wrap it with duct tape to make it air tight. Crank on the vac until all the water and obstructions are cleared out.

Make sure there is no standing water left around your air handler that can lead to a mold problem. Install a pvc "t" near the air handler and add 1 cup of bleach every month to prevent algae build-up. Rinse with water after each treatment to prevent chlorine gas from being drawn into the system.

2006-08-11 16:19:55 · answer #1 · answered by Elwood Blues 6 · 0 1

Do you know for sure that is the drain pipe for your AC unit or hot water heater.This just happened to me and the drain pipe is located in one of the bathrooms.Actually there are two.The main drain empties out under one of the sinks.It tees of the drain flush line.The backup drain goes outside and drains from the cornish,that is the flat area as you are looking up where the shingles stop.It is the bottom side of the overhang.If it is the drain from your AC unit then one of the drains are clogged.Rent a "snake" and run it in whatever PVC drain you need to.Sorry to say but on this end my experience was its a *****.Hope the best for you.

2006-08-11 16:21:33 · answer #2 · answered by kball572000 2 · 0 0

Listen to airboy hoss, he knows his stuff and is right on the money. I have read over the other answers and apparently nobody knows of a third choice.

I suggest you clean your drain as airboy suggests, but where he and I differ is in the prevenative maintenance end of things. Bleach does a great job of killing germs, but not so great if the clog is from something else.

There is actually a product on the market sold under the brand name of "KONTROL". It is actually a tablet that sits in the drain pan and slowly dissolves over the summer and prevents the clog in the first place. Kinda like what a urinal cake does in the bathroom.

I do not know where you live but "KONTROL" is readily available through Johnstone Supply, a national wholesaler of heating and cooling products.

2006-08-11 17:27:22 · answer #3 · answered by dont_call_me_sweet_pea 2 · 0 0

I go for the snake treatment.

Bugs or small animals could have gotten in the pipe.
Think spiders.
That & dust.

Then flush with clean water. If possible.

2006-08-15 14:45:30 · answer #4 · answered by Floyd B 5 · 0 0

Compress air at the entrance or exit, or a vacuum wet dry at the exit.
You can try to suck it out, or reverse the flow of Vacuum to blow it back, at the exit.

2006-08-11 16:14:45 · answer #5 · answered by albertm 1 · 1 0

shop vac works wonders....or compressed air works but shop vac is easier...then if you will pour a little bleach in the drain every few months it will keep the build up at bay in the future...

2006-08-11 16:05:59 · answer #6 · answered by Joshua S 2 · 2 0

It has a off cycle defrost which skill the unit has to coach off long adequate to soften the coils. Your settings are to low carry them as much as approximately 75 stages and while it extremely is sweet you are able to decrease to 70 stages yet no decrease. leave the fan purely and thaw the coils thoroughly off.

2016-11-04 10:08:16 · answer #7 · answered by ? 4 · 0 0

fedest.com, questions and answers