i have recently installed a chevy 350 in my jeep wrangler. i have welded the motor mounts in and i have use the adapter to bolt the motor up to my tranny bolted in the starter wired the alternator and i have hooked up all my P.S connections is there anything else i have to do
2006-08-07 13:12:21 · 6 answers · asked by Anonymous in Cars & Transportation ➔ Maintenance & Repairs
how bout fuel, radiator hoses, how bout vacuum lines, how bout, fan, belts, oil, coolant, p.s. fluid and then pray
2006-08-07 13:20:45 · answer #1 · answered by Christian 7 · 0⤊ 0⤋
be sure to wire all your sensors fuel line radiator vacum hoses if you welded the motor mounts it would be a very good idea to run a piece of chain bolt it to the frame and run it over and bolt it to the motor just incase the weld would break from the tourge thi s motor is going to put out need help e-mail me
2006-08-07 20:36:51 · answer #2 · answered by firefightingexpert 5 · 0⤊ 0⤋
Check your drive shaft and be absolutely sure that you have room on your slip yoke. The front yoke should have plenty of slack but the rear slip may be tight. If it doesn't have room to slide toward the transmission, you may end up destroying the tailshaft housing, bending the shaft, or damaging your motor and tranny mounts. Good luck.
2006-08-07 20:19:59 · answer #3 · answered by jeff s 5 · 0⤊ 0⤋
Ya Pray
2006-08-07 20:17:07 · answer #4 · answered by tom_allen95 2 · 0⤊ 0⤋
um exhaust....radiator..all eletrical coonections as well as a safe gas line..
2006-08-07 20:20:01 · answer #5 · answered by njctd03 2 · 0⤊ 0⤋
go through every thing one more time
2006-08-07 20:23:40 · answer #6 · answered by Stephen A 2 · 0⤊ 0⤋