I have a ViewSonic widescreen monitor and a great Intel Centrino 2.8Ghz with 1Gb Ram and plenty of hard drive space on my laptop. Once I connect everything and install the drivers, I press the Function and F8 key to try and switch from my laptop to the monitor but it isn't working. The monitor says No Signal even though everything is connected. What am I doing wrong?
2006-08-04 11:48:18 · 4 answers · asked by achristian520 2 in Computers & Internet ➔ Hardware ➔ Monitors
hi,
run the software again
check for loose connections
read the manual
configure settings onbig screen (if available)
configure the graphix card setting
goto desktop>right clcik properties> settings advanced >configureit!
last option! call customer care and blow their heads offfff
AnswerMan
2006-08-04 11:57:35 · answer #1 · answered by The AnswerMan ? (J.L.A) 4 · 0⤊ 0⤋
You need to set the correct resolution for the monitor to work.
2006-08-04 18:56:08 · answer #2 · answered by johndeereman 4 · 0⤊ 0⤋
Make sure you turn you laptop screen off (Shut the lid)
2006-08-04 19:04:23 · answer #3 · answered by fmtjatt 3 · 0⤊ 0⤋
fire wire, router not big enough, go through the steps again to check if all your plug and plays are installed
2006-08-04 18:55:01 · answer #4 · answered by BlackWidow 3 · 0⤊ 0⤋