The best way to remove mold or mildew is to scrape off the host's surface and soak it with a concentrate of bleach. Mold and mildew are organisms that feed on moisture and darkness. Poor air circulation is the major cause. Moisture stays if there's no air to dry it out, therefore the situation becomes perfect for mold growth. Make sure you keep both shower doors in the middle after use and leave the bath door open for good air circulation. Clean your bathroom regularly. good luck!
2006-08-04 02:36:54
·
answer #1
·
answered by BOBBY 2
·
1⤊
0⤋
I have the same problem and every two years I wind up digging some old caulk out and recaulking. It's a hard job. If you do this I don't suggest using caulk remover, it just makes a sticky mess. Use muscle. Fixing the problem is the best way to prevent it.
With that said...
I have tried Tilex AND the bleech pen and neither work on TOUGH jobs. So I bought a "mildew remover" from the hardware store. And it works great on my shower, deck, and house. I got a big jug and put it in an old spray bottle (and labeled it clearly).
2006-08-04 03:10:39
·
answer #2
·
answered by b 3
·
0⤊
0⤋
If you are seeing mildew under the silicone you need to remove all of the old silicone. Properly applied or functioning caulking should be water and air tight, mildew growing is a sign that moisture is getting in where it shouldn't be. After you remove all of the old silicone, clean the area thoroughly with a bleach solution or a cleanser that contains bleach, let it dry and then reapply your silicone. Follow the directions on the packaging to make sure you get a water and air tight barrier.
2006-08-04 02:36:39
·
answer #3
·
answered by bookworm mama 2
·
0⤊
0⤋
Clorox makes a bleech that is thicker so it doesn't spill. I have taken an old toothbrush and a cup of the stuff and used it on the silicone. It takes about 2 hours of drying time but it will look brand new!! Beats anything I have ever used including Tilex! Caution it is strong so use your window or vent.
2006-08-04 02:30:33
·
answer #4
·
answered by Karrien Sim Peters 5
·
0⤊
0⤋
Dig out the silicone, bleach the mildew, clean it up, and re caulk with clear latex, it has a mildewcide built into it that silicone doesn't have.
2006-08-04 02:42:35
·
answer #5
·
answered by uncle bob 4
·
0⤊
0⤋
I would try a bleach or bleach paste (Clorox Pen). If it persists scrape off the silicon and re caulk.
2006-08-04 02:30:39
·
answer #6
·
answered by adieu 6
·
0⤊
0⤋
Go to Lowe's get this and spray your area with this mixture
1 part bleach
1 part simple Green
2 parts water, spray it heavy
weekly cleanings will solve the problems
2006-08-05 14:56:51
·
answer #7
·
answered by mr_jim51 3
·
0⤊
0⤋
bleach....kills mildew
2006-08-04 02:39:30
·
answer #8
·
answered by laney45 4
·
0⤊
0⤋
tilex
2006-08-04 02:28:53
·
answer #9
·
answered by ROSIE 3
·
0⤊
0⤋