2006-08-01 04:38:52 · 4 answers · asked by phillip r 1 in Cars & Transportation ➔ Maintenance & Repairs
If you're talking about lugs (where your lugnuts go that hold your wheel on), all you need is a hammer. Just hammer them straight back and they will fall out. Your new ones will squeeze into the holes as you tighten the lugnuts.
2006-08-01 04:51:59 · answer #1 · answered by garjar22 1 · 0⤊ 0⤋
DO NOT---REPEAT---DO NOT USE A DRILL!!!!!!! The hammer is about all you will need. if your rear brakes are drum just remove the drum--rotate your axle to a spot that will let that stud be hammered out and do it. Start the new stud into the hole and use your lug nut [get a new one of these while you're at the parts store because something caused you to have to replace this one] to pull the new lug into place. If it's on the front/disc brakes you will probably need to remove the rotor, but there is no reason that you should get junk into your bearings if you are the least bit careful!!--use paper towels to 'PLUG" the holes where your spindle goes through and toss them away when you're done.
2006-08-01 05:19:19 · answer #2 · answered by Gary Gearfreak 3 · 0⤊ 0⤋
You'll have to pull your rotors/drums (depending on the type brakes you have on the wheel with the studs), then you can take a punch and hammer and drive the broken stud out from the front of the rotor/drum. You may need to add some liquid wrench to help brake loose the rust. If you have to, you could drill out the old stud (be carefull not to over-drill the hole) or you can take the rotor/drum to a shop and have them replace the stud. You may need to replace your wheel bearings when you do it, you'll probably end up getting foreign material in the inner bearing.
2006-08-01 04:53:40 · answer #3 · answered by Jeffrey S 6 · 0⤊ 0⤋
A 4-sale sign.
2006-08-01 04:43:27 · answer #4 · answered by Billy M 4 · 0⤊ 0⤋